Want this question answered?
Sure. 12 yards is 36 feet, so the truck can easily carry 25 foot logs. ■
They both r logs
The spaces between the logs are filled with chinking.
Logs are meant to be read to the public and are factual, Diaries are personal and opinionated.
Logs are logarithms, Napier's Bones were a very early calculating device produced by the inventor of logarithms
== == Since each of the log rules was developed using different methods with different assumptions, it is logical that they will not always result in the same volumes for given size logs. Table 1 shows a comparison of the three log rules for 16-foot logs ranging in diameter from 6 to 40 inches. Compared to the International Rule, both the Scribner and Doyle Rules underscale logs of smaller diameters. For example, a 12-inch-diameter log contains 95 board feet on the International scale, 80 board feet on the Scribner scale, and 64 board feet on the Doyle scale. Overall, the Doyle Rule will result in lower log volumes than the International Rule, up to a log diameter of 30 inches. Since nearly all logs in Virginia are below 30 inches in diameter, for all practical purposes the Doyle Rule will underestimate the actual board footage. If you are selling stumpage or logs, it is important to recognize the differences in volume associated with the different log rules. Since stumpage or log prices are based on the timber or log volume, you will receive substantially more income with the rules that scale your sizes higher. For example, take a log of 16 inches diameter x 16 feet in length and a value of $100 per thousand board feet. This log would have the following volumes and values based upon the different log rules: {| ! LogDiameter(in.) ! Log Rule ! Volume(board feet) ! Value ($) | 16 International 180 18.00 16 Scribner Decimal C 160 16.00 16 Doyle 144 14.40 |}
a cord of wood is the amount of wood in a stack of 48-inch logs (or cut logs equaling 48 inches) that is 4 feet high and 8 feet wide
Sure. 12 yards is 36 feet, so the truck can easily carry 25 foot logs. ■
The weight of a pine is estimated by calculating the board footage of the tree. To do this it is necessary to have the length and circumference of the logs. To find the weight, one will need to multiply the diameter of the small end of the log by the length of the log. This is then multiplied by 0.37. 50.93 is added to this total. This results on the predicted weight in pounds. There are many factors, such as moisture content, that can affect these numbers.
It would have been a matter of the weight of the blocks, as they usually weighted several tons they had nothing strong enough to bear such weight. With logs it was the ground which bore the weight.
I am assuming this is on the grand exchange, willow logs sell for ridiculously little. This is the reason they are usually used as weight in trades. I have not checked the general store sell price for this item.
They both r logs
are they buying cedar logs and how much they paying are they buying cedar logs?
The conversion is not possible.Ton is a unit of mass and cubic meter is a unit of volume; you need the density.
The lifespan of propane gas logs depend on many different things. If the logs are 'vented gas logs' and made from heavy ceramic that take the flame directly will only last a given amount of hours until the heat of the LP breaks them apart, something like 2-3 years with normal use. A vented set using light weight ceramic fiber logs will last almost forever. If the logs are 'vent-free' they will last several years as well, until the burner burns up from the heat of the LP, but the logs themselves will last forever on any 'vent-free' gas log.
animals live's in logs
log rolling, two folks on a log, they try to roll the log with their feet and get their opponent to fall into the water.