answersLogoWhite

0


Best Answer

ground wire, all the metal on the car is where any electricial device can be connected to.

User Avatar

Wiki User

16y ago
This answer is:
User Avatar

Add your answer:

Earn +20 pts
Q: What is the wire that is connected to the hood and fastened to the fender?
Write your answer...
Submit
Still have questions?
magnify glass
imp
Related questions

Where is the single wire in line spout connector on 93 f150?

Drivers side fender well by the hood hinge


How to open your hood on a 1990 Honda civic LX cable broken?

theres a wire that is attached to the hook that keeps your hood down, if you can see that wire good. now let me tell you: i have a 92 civic, what i do is pull that metalic wire to left away from the hook and it releases the hood. My wire is connected to the hook but not to the release button inside the car. so if your wire is still connected at both ends you might have more trouble opening your hood.


How do you disable the horn on a 1992 Mazda Protege?

Open hood and disconnect the wire from the horn itself located under right front fender.


How do you open the hood on 1999 New Beetle if plastic hood release tab under edge of hood is broken?

"pop" the hood with the in car lever. get a pair of pliars and grab the wire that the plastic hood release was connected to.....this should work!


How do you get to the battery in a Cadillac deville to replace it?

You would have to pop the hood of the car. If the handle is broken to the hood, you must locate the piece of the wire that it was connected to and pull on it with a pair of pliers.


Where is the control module located on 1984 Dodge D100?

under hood,Drivers side firewall or inner fender. 4or5 wire plug with a screw in it to hold it.


Where is the T connector on a 1986 Toyota 4Runner?

under hood..drivers side inner fender (apron)..will look like two connectors plug into the fender....it's the two wire plug....pull it and cross it out with a jumper wire to set timing...(about 5 degrees should do it)...don't forget to unplug the jumper...t


Where is the coolant temperature sensor on a 2000 Dodge Caravan V6?

Under the hood connected to a electric wire to the dash plugged into ur a hole


You want to disconnect the power to the Power antenna on a 1989 caprice classic How do you do this?

There is a wire which connects the power to the antenna. The wire is located under the hood right near the back of the fender hump on the passengers side. If you look you will see where it goes down insdie the fender to the antenna power unit. Just unplag the connector and you are good to go. vbdenny


Where is the heater fan on a 1991 Cadillac brougham?

it is on the passenger side right next to the windshield under the hood it is black and has a purple and black wire connected to it


If you have a 2004 LeSabre without a tach can you swap this instrument cluster out with one with a tach?

It should work ok if the wire for the tach under the hood is connected and I don't remember which one it is.


How is a viper alarm installed into a vehicle?

One can install a Viper alarm system with minimum electrical knowledge. The system has 12 wires. The red and white wire need to be connected to the trunk release wire. The fuse of the red wire needs to be attached to the 'plus' terminal of car battery. The brown wire needs to go to the siren of the car, the yellow wire to the 'plus' of car ignition, the black needs to be attached to the hood as ground, purple wire with 'minus' of dome light, green wire with 'plus' of dome light, blue wire with the sensor pins and orange wire with the hood.