0
The Dual BP1204 Woofer Box should operate properly with a power amplifier rated 600 Watts Peak or more into 4 Ohms.
Wiki User
∙ 14y ago
Add your answer:
Earn +20 pts
What amp plug should a vacuum have?
Generally, a 15 amp plug.
Can you have an 18 amp appliance on a 20 amp circuit?
You should not exceed 80% of the breaker rating for a continuous load. Therefore, the continuous load should not exceed 16 amps.
What size amp circuit breaker should be used for a well?
Usually 30 Amp 240 volts, but there will be a spec on the well pump.
What appliances require a 20 amp outlet?
Any appliances that draw over 1500 watts should be on a 20 amp circuit.
What size amp breaker for a 220V air conditioner?
a 2p 20 amp should work fine for a single 220 air conditioner,
Is a dual amp a good amp?
for a fist amp its not bad but dont screw your subs over if you have good subs and a bad amp. go with hifonics or somthing good if willing to spend,
If you are buying two 12 inch dual 2 ohm subs with 400 RMS each what kind of amp should you get and how much RMS should the amp have?
You should get a 1 watt amp so I don't have to listen to your plastic BS "Boom Boom" noise and rattle as you ignorantly careen down the street, blissfully unaware of whats going on around you.
What is the amperage of the alternator on a 2004 F-250 6.0l diesel?
With single alternator , 110 amp -------------------------------------------------------------------------------- With dual alternators : lower , 120 amp , heavy duty upper , 140 amp , heavy duty
Correct way to hook up pioneer 12Ins sub woofer's champion series?
Depends if it is dual 4Ohm or dual 2Ohm and what Impedance your Amp supports. *If you amp can handle 1Ohm Load and you have a dual 2Ohm sub you can run the sub in parallel to get a 1Ohm load (parallel meaning both + are connected with each and same with both -) *If your amp can handle 2Ohm load and you have a dual 4Ohm sub you can run the sub in parallel to get a 2Ohm load. *If your amp supports a 4Ohm load and you have a dual 2Ohm sub you can run the sub in series to get a 4Ohm load. (series meaning the - from one coil is to be connected with the + on the other coil) Do not mix up Impedance's make sure you find out what your Subs Impedance is and what you Amps Impedance is
What do you set your amp to for 2 12 subs?
to mono if your amp will allow, also this is for single voice coil. otherwise run in mono parallel to run dual voice coils.
What maker or model amplifier is a KA-1460B 4 Channel 800 Watt amp?
The maker or model amplifier that is a KA-1460B 4 channel 800 watt amp is Dual Electronics. Dual Electronics is the maker of high quality home, marine, and car audio solutions.
How do you wire a dual voice coil to an amp?
If you want to run both coils,you have to wire the positive to positive and negative to negative on your sub,then run a wire from each plug to the amp. Positive to the positive side of the amp and negative to negative side of the amp,(you can run in bridge mode or stereo if your amp can handle the load)
How many watts can the stock alternator handle on a Ford Focus?
it is not watts, but amps. If you are just adding a stero you should be fine. But, if you are adding several amps and equipment, check into a higer amp alternator (good luck on a Focus) and dual batteries with an isolator. If you run dual batteries without the isolator it will not work as well.
What amp plug should a vacuum have?
Generally, a 15 amp plug.
Does the factory stereo in a 2003 silverado have an amp?
depends what kinda system the factory put in it .. if its a base system (UQ3 /UQ5) then the amp would be in the radio, if it has a Bose system (UQ7) the amp will be either under the front seat in the centre or under the centre console.
What is a good amp for MTX Terminator?
if it is the dual 12 package, your best bet for a inexpensive good quality amp to match the mtx name would be a mtx 250-1, thats what i have for mine and it sounds great.
What is the most recent Marshall Combo Amp?
The most recent Marshall combo amp is the DSL All Valve series. The series was released in 2012 and is based in the JCM2000 DSL100 head. The amp has an excellent sound with all-valve Dual Super Lead, or DSL, amps.
