0
What mechanism is used to connect two parallel non collinear shaft?
Wiki User
∙ 11y ago
oldhamn copuling was used
Wiki User
∙ 11y ago
Add your answer:
Earn +20 pts
Are thrust loads at a right angle to a shaft?
On a ships propeller shaft, the thrust will be in line with the axis of the shaft.
What is an angle shaft?
An angle shaft is an enriched angle bead, with a capital, base, or both.
What is a synonym for axis?
shaft, pole, pivot, stem
What are the applications of counters?
used in rotary shaft encoder
How does an elevator shaft look?
it looks like a black square
What does the universal joint on the propeller shaft of an automobile function?
The universal joint is used to transfer drive (power) from one shaft to another when they are inclined (non collinear) to each other.
Hogan apex blade iron heads parallel or taper tip?
They're taper tip. The Apex shaft (red band) is a proprietary shaft with that company. A parallel shaft will not fit.
What drives the gearbox input shaft?
the input shaft has splines on it which connect to the clutch friction plate.
How to connect a mechanical load to a motor?
To connect mechanical load to a motor, you couple it to the shaft of the motor.
Can electricity be regenerated by connecting electric motor to a dynamo?
The question is mine......take one dynamo and a motor (both of them are DC).. If The Dynamo is 12v and the motor is 9v...and connect together.....means the rotating shaft of a motor is connecting using a belt then the other end connected to the rotating shaft of the dynamo ......connect the wire parallel......let start... take a cotton thread of 15 cm ...then round the thread on dynamo rotating shaft the pull it....the current from dynamo flows to motor that action make the motor rotates but not constant.....
What type of simple machine is connect to a shaft of a wheel and axle?
Lever a+
How do you connect the rack and pinion to the steering column in an 04 Pontiac Grand Prix?
The steering column is connect with a shaft that runs from rack and pinion to steering column. A short shaft sticks out of rack and pinion and is attached to shaft with 1 bolt that goes thru the coupler. Usally hid under a boot that goes around the shaft.
Why shaft generator can not operate in parallel with auxiliary generator?
Normal shaft generators do not have droop-control for frequency and voltage. Semiconductor (drive) based variable speed shaft generators may have those today.
What are the different parts of?
There are 2 parts of a Lever mechanism: 1.) The lever (shaft) itself ... 2.) the Fulcrum.
How do you remove the steering wheel with radio controls out of a 1991 grand prix?
The rubber membrane over the radio buttons has to be pulled out to reach the shaft of the steering column. Remove the screws holding the turn signal mechanism and the handle attached to it. Gently pull the mechanism out and away from the shaft. The center of the wheel is attached to the shaft by a nut on a splined shaft. After removing the nut the wheel can be wiggled and pulled off; UNLESS it is a tilt-steering mechanism. They have an extra screw on the right side of the column that requires a special tool to remove. Most part stores will have it.
What is the mechanism behind a foam cutter ?
the saw being of the type having an oscillating drive shaft and a counter weight that oscillates in opposing phase to the drive shaft for the purpose of reducing vibration.
what are the different part of lever?
There are 2 parts of a Lever mechanism: 1.) The lever (shaft) itself ... 2.) the Fulcrum.
