Want this question answered?
Yes, but there must be two pairs of opposite sides that are equal.Yes, but there must be two pairs of opposite sides that are equal.Yes, but there must be two pairs of opposite sides that are equal.Yes, but there must be two pairs of opposite sides that are equal.
There is no such object. Every quadrilateral must have adjacent sides. In fact, every polygon MUST have adjacent sides.
An isosceles trapezoid must have a pair of parallel sides and a pair of congruent sides
A polygon must have 3 or more sides as with a triangle for example
No but a regular heptagon must have equal sides.
If the bullet itself must be marked (not recommended) they markings could be applied to the base, leaving ballistic markings on the sides undisturbed.
4 ft.
4 ft.
In that triangle, one of the angles must be a right angle, and another one of the angles must be marked with or the measurement of the angle. Tangent is the ratio of opposite side over adjacent side. The opposite and adjacent sides are determined by the position of the marked angle.
This answer is DIRECTLY from the Florida Drivers Handbook:In the day time,4 red flags at least 12 inches square must be placed on the projecting load where red lamps are used at night (extreme rear and sides)NOTE: if the trailer or motor vehicle is transporting logs, long pulpwood, poles or posts that extend more than 4 feet beyond the rear of the load, then you must have one amber strobe-type lamp equipped, so that the lamp is visible from the rear and both sides of the projecting load. The lamp must be operational and seen any time of day or night.>I hope this information was great use to you...GOOD LUCK on your exam! =D
When checking in a load, what must be done with cases that say "Mixed" on them
The safe lifting load of any crane that has been properly installed and maintained is determined by the engineering spec. a Crane is designed from the beginning to lift a load by transferring that load through the supporting structure to the ground or/ to the floating vessels structure in the case of a floating crane. All cranes are required to be marked for max capacity, and if it is not marked, get the serial number and contact the manufacture. If no information is available a certified PE must calculate the load limit.
Yes, but there must be two pairs of opposite sides that are equal.Yes, but there must be two pairs of opposite sides that are equal.Yes, but there must be two pairs of opposite sides that are equal.Yes, but there must be two pairs of opposite sides that are equal.
When checking in a load, what must be done with cases that say "Mixed" on them
When checking in a load, what must be done with cases that say "Mixed" on them
All four sides of a rhombus must be congruent. In order for it to have four equal sides, it must have two!
An isosceles trapezoid must have a pair of parallel sides and a pair of congruent sides