Want this question answered?
Hydrophobic head and tail is the sequence that represents a cross of the bilayer. This is all the same member. this is bull
The fraction is(thickness of the thinnest layer)/(thickness of the thickest layer) After you write that fraction, you can simplify it if you feel like it.
Plywood is manufactured from thin sheets of wood. Where as PLY means layer of Material. Hence LAYER(s) OF WOOD = PLYWOOD
In square close-packed layer, a molecule is in contact with four of its neighbours. Therefore, the two-dimensional coordination number of a molecule in square close-packed layer is 4.
You could start with 100% energy for the first layer, 10% for the second layer, 1% for the third and 0.1% for the fourth layer. If the biome is very poor in producers, you could start with 50%, 5%, 0.5% there would be only 0.05% for a fourth layer and it would not support anything.
Hydrophobic head and tail is the sequence that represents a cross of the bilayer. This is all the same member. this is bull
Is the older segment of fossil
is the oldest
The interior of Saturn is probably composed of a core of iron, nickel, silicon and oxygen compounds, surrounded by a deep layer of metallic hydrogen, an intermediate layer of liquid hydrogen and liquid helium and finally, an outer gaseous layer
As a geological reference, the basal reflection is referring to the bottom layer. In a seismic profile at the cross section of the subsurface, the basal reflection would be a particular dense layer at the bottom of the formation.
Transport layer .....
In a normal sequence (ie one that has not been tectonically deformed) the oldest layer is the lowest layer - so the one at the base of the sequence is the oldest. This is called the "law of superposition".
The bottom layer of rock in a geologic sequence is usually called the basement layer.
Cross-cutting can give insight to whether or not a certain layer is older or younger than what is cross-cutting it. Say if a dike was cross-cutting layer A, then layer A is older than the dike.
It is called an uncomformity.
In incompressible fluid density is same because velocity gradient is same on every layer of liquid at any cross section.
physical layer