I used plumber's putty to fill the holes. It stays soft and maleable. That might work for you too.
Plumber's putty will not allow you to paint or stain. If you need either of those abilities you need to use a latex exterior wood filler/putty or a urethane based caulk that stays flexible and is paint and stain accepting. You can also use wooden dowel rods, found at hardware and home improvement stores, cut to length (approximately 3/4 inch long) with wood glue to fill simple holes.
I think you should say hey this is everone's home.You are making it messy. Its not that hard to put it in a garbage can.
It is very good for making cans, but the inside should usually be coated (especially if the contents will be acidic) with a plastic film to prevent corrosion of the steel.
YES. In fact, we have several robots there now making houses for us. We should be able to move there in a few years.
If science isn't published, the information is not available for people to receive, thereby making the study pointless.
Each should be 70
Carpenter jobs should be plentiful this time of year. In Houston, Indeed website is listing carpenter jobs like cabinet maker, foreman, and carpenter helper jobs.
They both handle a plane, but a carpenter shaves wood, while a pilot should wave. Okay, joking aside, a pilot flies airplanes while a carpenter works with wood.
A Trade Qualified Carpenter should be able to answer that
No it will be drilled into his head and he will disrespect you
According to Hammurabi Code of Law, the Carpenter who built the house that kills its owner upon destruction, and if that destruction is caused by compromised and inept building skills, should be sentenced to death.
Stereo Microscope
drill a hole, ive drilled several holes in my shaft for different heads and its fine, but you may also want to tape still to assure that the screw will not fall out while your playing
I'm going to guess you're in Providence where Carpenter and Dorrance are about 1 mile apart. If you're in another of the many possible locations, you should have mentioned that.
Carpenter or any ither wood worker. However, the question should be iron is to blacksmith as wood id to? If wood was to carpenter as blacksmith is to iron, then we are thikning of bizzarro world.
No, it's too hard. You should use a fine hacksaw.
Well that depends on experience, and level of work performed. But in 2009, a Carpenter's helper should make anywhere between $9.50/hr to $13.00/hr. Obviously, the higher pay comes with more responsibilities, such as framing, drywall, finishing, etc. And the term carpenter does not mearly suggest wood and framing. Today's carpenter's are skilled in most building procedures. However, a Master carpenter, or Craftsman, suggest woodworking as the predominant trait of the profession
You should be good with 5th grade math. A geometry course wouldn't hurt.