answersLogoWhite

0


Want this question answered?

Be notified when an answer is posted

Add your answer:

Earn +20 pts
Q: What size equipment bond for 300 amp sub panel?
Write your answer...
Submit
Still have questions?
magnify glass
imp
Continue Learning about Electrical Engineering

What size aluminum wire on 225 amp?

300 kcmil @ 75°


What gage wire do you need to run for 200 amp sub panel 300 ft from electrical panel?

Using AWG # 3/0 copper wire you will have a voltage drop of around 3.8% at 68 degrees Fahrenheit. This should be acceptable to your local inspector but you may want to call them and make sure.


What size conduit for 3 500 mcm wires?

The required size of a conduit raceway for a 3-5000 mcm wire is 300 kcmil. It maximizes the limits on the wire fill for raceways.


What wire size is needed to ground a 300 amp service panel in USA?

Notes: 1. Where multiple sets of service-entrance conductors are used as permitted in Section 230-40, Exception No. 2, the equivalent size of the largest service-entrance conductor shall be determined by the largest sum of the areas of the corresponding conductors of each set. 2. Where there are no service-entrance conductors, the grounding electrode conductor size shall be determined by the equivalent size of the largest service-entrance conductor required for the load to be served. 1 This table also applies to the derived conductors of separately derived ac systems. 2 See installation restrictions in Section 250-64(a).


LRA is 134 AMPS. what size breaker should be used?

LRA (locked rotor amps) is not used to calculate the breaker size. Breaker's are used to protect the size of the conductor that is connected to it. Motor calculations are based on the motor's FLA (full load amps).Conductor size is 125% of the motor's FLA.Breaker size is 250% of the motor's FLA.This is the only occasion when the breaker is sized larger that the conductors maximum amperage rating. This is due to the motor drawing up to 300 to 600% of its FLA when starting.If you state the motor's wattage, voltage or amperage this calculation can be calculated here.

Related questions

What is the normal size resolution for pdf in short bond paper?

The normal size resolution for a PDF document on short bond paper is typically 8.5 x 11 inches (215.9 x 279.4 mm) at a resolution of 300 dots per inch (DPI). This is the standard size for letter-sized paper commonly used for printing documents.


Where to find cheap glass panel 32x80 in?

$300


Can a 2001 Chrysler 300 rocker panel fit a 2005 Chrysler 300?

No. They are completely different.


Can you bond out on theft over 300 in Illinois?

No. Not at the police station anyway. Theft Over $300 is a felony in Illinois. You have to go to the county jail and go before a judge who will set bond.


How do you remove 1992 Mercedes 300 SE rear door panel?

You can remove the rear door panel from your 1992 Mercedes 300 SE by removing the clips on the perimeter of the door skin. Once the clips are removed the door panel should come off.


What is the base engine size of the 2011 Chrysler 300?

The 2011 Chrysler 300 has a 3.6 L base engine size.


What is the base engine size of the 2009 Chrysler 300?

The 2009 Chrysler 300 has a 2.7 L base engine size.


What is the base engine size of the 2014 Chrysler 300?

The 2014 Chrysler 300 has a 3.6 L base engine size.


What is the base engine size of the 2005 Chrysler 300?

The 2005 Chrysler 300 has a 2.7 L base engine size.


What is the base engine size of the 2007 Chrysler 300?

The 2007 Chrysler 300 has a 2.7 L base engine size.


What is the base engine size of the 2013 Chrysler 300?

The 2013 Chrysler 300 has a 3.6 L base engine size.


What is the base engine size of the 2006 Chrysler 300?

The 2006 Chrysler 300 has a 2.7 L base engine size.