answersLogoWhite

0


Best Answer

A 200 amp service using a uffer ground will need a #3 bare copper wire. The bare copper wire is to be not less than 20 feet in length. It also has to be within 2" of the concrete foundation footing that is in direct contact with the earth. The depth can not be less than 2 feet below finished grade.

User Avatar

Wiki User

12y ago
This answer is:
User Avatar

Add your answer:

Earn +20 pts
Q: What size uffer ground for 200 amp service?
Write your answer...
Submit
Still have questions?
magnify glass
imp
Related questions

Ground wire size for 200?

A 200 amp service panel will require a # 4 bare copper ground wire.


What size ground wire is needed for 200amp service pannel in Chicago?

200 amp service in chicago uses 3 aught.


How do you know what size ground wire to use on a 200 amp service?

NEC code requires #6 bare copper.


How do you know what wire is ground on 200 amp service?

On a 200 amp or any size service the ground wire is easily identified. Look in the distribution panel for the neutral bus bar. This is where the service neutral (white wire) is connected to the distribution panel. There you will see a bare copper wire connected to the same neutral bar. This is the ground wire that is connected to the ground rods out side of the house.


Are there negative wire gauges?

Yes, there are ground wire gauges. The approiate size ground wire must be matched to the size service you are installing. For instance a 200 amp serivce must be grounded with a # 4 bare copper ground wire.


What size cold water ground for a 200 amp residential service?

#4 bare copper connected to two 8' copper ground rods 6" apart driven into the ground.


What is the minimum size of service entrance conductor?

The wire that is used for connecting the ground rod or plate to the electrical distribution is governed by the size of the electriclal distribution. In Canada a #6 bare copper is the minimum size for a 200 amp service.


What size ground on 200 amp service?

In Canada it is a #6 bare copper conductor that connects the grounding rod or plate to the neutral point in the distribution panel.


Is number 3 copper ground conductor a common conductor size?

Answer for USA, Canada and countries running a 60 Hertz supply service.CEC states that a #3 bare copper conductor is a common grounding conductor size for a 200 amp service panel and it is the minium size for service raceway and service equipment of 400 amps.


What size wire for 200 amp service with a 60 foot run?

This can't be answered without knowing the voltage, and ground is not the same as neutral, in AC circuits, which I'm assuming this is.


What wire size to use from breaker box to earth ground rod?

The wire size used in a service entrance distribution panel is governed by the size of the services over current device. The larger the service, the larger the fault current could be, the larger the ground wire to carry the fault current to ground. If the largest service conductor carries 100 amps use a #8, 200 amps - #6, 400 amps - #3, 600 amps - #1, 800 amps - 1/0 and over 800 amps - 2/0 for the ground wire. <<>> Golden Valley Electric Assoc. in Alaska requires #4AWG copper wire for a ground from the breaker box to earth ground rod. The same goes from the service entrance panel on the pole.


What size grounding wire do you use as the 4th wire running in your conduit from your 200 amp meter box to your 200amp service panel this is the ground wire from box to box?

You do not use a ground wire in the connection from the meter base to the distribution panel. A bonding wire may be required if the service is using PVC conduit.