Depends entirely on current draw. The higher the current, the higher the draw. For example, the wires in a radio may be pretty small, while the wire to operate your stove is pretty large. The wires to operate an overhead electric locomotive or trolley may be 8 to 12 inches across.
In house wiring, the standard in most places is 14 guage for the lighting circuits, 12 guage for the convenience outlets, and bigger guages for the clothes dryer and stove.
You will need to use #8 wire.
6millimeter square.
The sizing of a breaker is dependant upon the size of the wire it protects. The size of the wire is dependant upon what the load current in amps is. Without the amperage and wattage and the voltage of the appliances an answer can not be given. W = A x V, Amps = Watts/ Volts.
A # 10 wire with a insulation factor of 75 or 90 degrees C are both rated at 30 amps.
Need to know the voltage of the mixer.
You will need to use #8 wire.
Wire size is based on the amperage of the connected load. Without that amperage an answer can not be given.
10 guage
6millimeter square.
Wire size is not dependent on voltage - it is dependent on current. Please restate your question and provide the expected branch current.
The sizing of a breaker is dependant upon the size of the wire it protects. The size of the wire is dependant upon what the load current in amps is. Without the amperage and wattage and the voltage of the appliances an answer can not be given. W = A x V, Amps = Watts/ Volts.
6
A gigantic expensive cable run of #8 gauge wire to a 3:1 transformer.
Read the literature for the ac condensing unit, or the tag on the outside of the unit. Minimum circuit ampacity= minimum breaker, wire and fuse size. Maximum circuit ampacity= the maximum size. Your circuit breaker, wire size and disconnect fuses should all be at or between those 2 numbers.
The wire size depends on the amperage, not the voltage. The fact that the welder runs on 440 volts does not affect the wire size! You need to ask this question instead: What size wire do you need for a three phase welder on an eight foot run if the nameplate amps are 45A?
A # 10 wire with a insulation factor of 75 or 90 degrees C are both rated at 30 amps.
Use AWG #6 wire.