0
What else can I help you with?
What wire size for 100amp load for distance of 1000ft?
At that distance you will have a voltage drop of 81.25 volts if you use the recommended #6 wire on a 240 volt, 100 amp single phase circuit. Therefore I recommend you contact you electric utility and let them figure the voltage drop and the size wire required to safely run this distance. Using too small a wire can damage the electronics at the end of the run.
What size wire for 100amp?
8 is the size of wire to use for grounding a 100 Amp panel. Green is color used for grounding8 is code.A #3 copper wire with an insulation rating of 75 or 90 degrees C is rated at 100 and 110 amps consecutively.
What wire size for 400 amp service neutral size?
You need to look at the regulations that apply in your country. If in doubt, use a neutral wire of the same size as the live wire or wires.
What size of wire cu do you need for 50 amps?
6 AWG.
What size wire do you need for 15 amps?
AWG 10.
What is the recommended wire size for a 100amp electrical circuit?
The recommended wire size for a 100 amp electrical circuit is typically 3 AWG copper or 1/0 AWG aluminum.
What size copper wire to use for a 100amp single phase three meter service feed from the riser?
A #3 copper conductor with an insulation factor of 90 degrees C is rated at 115 amps.
What size wire do I need for a 30 amp breaker?
For a 30 amp breaker, you will need a wire that is at least 10 gauge in size.
What size wire do you need to wire a 200 am breaker box?
6
What size wire do I need for a dryer installation?
For a dryer installation, you typically need a 10-gauge wire.
What size wire do you need for 440 three phase welder on an eight foot run?
The wire size depends on the amperage, not the voltage. The fact that the welder runs on 440 volts does not affect the wire size! You need to ask this question instead: What size wire do you need for a three phase welder on an eight foot run if the nameplate amps are 45A?
What size of electrical wire need to pass 50A?
Use AWG #6 wire.
What size wire do I need for a 50 amp breaker?
For a 50 amp breaker, you will need a wire that is at least 6 gauge in size to safely handle the electrical load.
What size wire do I need for my electrical project?
The size of wire you need for your electrical project depends on the amount of current the circuit will carry. Consult the National Electrical Code (NEC) or a qualified electrician to determine the appropriate wire size for your specific project.
What is the recommended gauge for 100amp wire in a residential electrical installation?
The recommended gauge for 100 amp wire in a residential electrical installation is typically 3 AWG copper or 1 AWG aluminum.
What wire size for 100amp load for distance of 1000ft?
At that distance you will have a voltage drop of 81.25 volts if you use the recommended #6 wire on a 240 volt, 100 amp single phase circuit. Therefore I recommend you contact you electric utility and let them figure the voltage drop and the size wire required to safely run this distance. Using too small a wire can damage the electronics at the end of the run.
How you can produce 240 volts from a single phase 3 wire system with a nominal voltage of 120 volts?
you can use two hot wire different phases with a double pole braker .
