0
What else can I help you with?
What size wire do you need for a 100amp braker?
Service entrance wire should be AWG #3 copper.
What wire size for 100amp load for distance of 1000ft?
At that distance you will have a voltage drop of 81.25 volts if you use the recommended #6 wire on a 240 volt, 100 amp single phase circuit. Therefore I recommend you contact you electric utility and let them figure the voltage drop and the size wire required to safely run this distance. Using too small a wire can damage the electronics at the end of the run.
How big is 6 gauge wire?
The size of the wire is stated by its gauge under American Wire Gauge. Six gauge wire is size 6 AWG.
What size wire is required for 277 volt fluorescent lighting?
Wire size is governed by amperage not voltage. Voltage is an insulation factor when talking about wire. Add up the amperage of fixtures you want in the circuit. Once that is found then the size of the wire can be calculated.
What size wire to use to install a thermostat?
Use what is called bell wire or thermostat wire.
What size wire do you need for a 100amp braker?
Service entrance wire should be AWG #3 copper.
What is the recommended wire size for a 100amp electrical circuit?
The recommended wire size for a 100 amp electrical circuit is typically 3 AWG copper or 1/0 AWG aluminum.
What size copper wire to use for a 100amp single phase three meter service feed from the riser?
A #3 copper conductor with an insulation factor of 90 degrees C is rated at 115 amps.
What is the recommended gauge for 100amp wire in a residential electrical installation?
The recommended gauge for 100 amp wire in a residential electrical installation is typically 3 AWG copper or 1 AWG aluminum.
What wire size for 100amp load for distance of 1000ft?
At that distance you will have a voltage drop of 81.25 volts if you use the recommended #6 wire on a 240 volt, 100 amp single phase circuit. Therefore I recommend you contact you electric utility and let them figure the voltage drop and the size wire required to safely run this distance. Using too small a wire can damage the electronics at the end of the run.
How many single phase can you run on a 100amp 3 phase?
You can divide a three phase service into (3) single phase circuits providing you have a 4th neutral wire.
What is the maxi fuse resistance?
100amp
What is the recommended ground wire size according to the NEC Ground Wire Size Chart?
The recommended ground wire size according to the NEC Ground Wire Size Chart is based on the amperage of the circuit.
What size wire for 100amp. 12vdc?
For a 100 amp 12VDC circuit, you would typically use 2/0 AWG (00 AWG) wire to ensure proper conductivity and safety. This size of wire is rated for up to 150 amps in most applications, providing a good margin for the 100 amp load. Be sure to consult local electrical codes and standards for specific requirements.
What can I use in place of 100amp fuse?
Another 10 amp fuse. If you use anything larger, you can fry your equipment, cause a fire, and so on. If this fuse is blowing all the time, there is a short in the component or wire.
When is wire size and electrical hazard?
Wire size is the gauge (thickness of wire) hazard is almost anything not wired correctly.
What is the recommended wire size for a range installation?
The recommended wire size for a range installation is typically 8-gauge wire.
