answersLogoWhite

0


Best Answer

Use what is called bell wire or thermostat wire.

User Avatar

Wiki User

10y ago
This answer is:
User Avatar

Add your answer:

Earn +20 pts
Q: What size wire to use to install a thermostat?
Write your answer...
Submit
Still have questions?
magnify glass
imp
Related questions

What size breaker can you use on a 7500watt generator?

Depends on the wire size you are using. If the generator breaker is a 30 amp then install a 30 amp breaker.


How do you install a thermostat on a 1987 Nissan 300ZX?

To install a thermostat on a 1987 Nissan 300ZX, remove the two nuts and one bolt on the lower water neck. Slip off the old thermostat and use a gasket sealant to secure the new thermostat.


How do you install a ceiling fan to plug into a wall outlet and should you use two or three strand electrical cord and which strand on the cord connects to which fan wires?

The neutral wire will have writing or ribs on it and connects to the white wire. The smooth wire is hot and connects to the black wire. Use 3 strand wire in size AWG # 16. If the fan has a light it will have a blue wire. Connect that blue wire to the black wire.


What size wire do you use if you are require to wire a 6-20amp 220volt outlet?

# 6 wire


What size wire to use to run electric six hundred feet from the panel it will be for ceiling fan and six outlets?

I would install a 60 amp sub-panel and use AWG #3 copper.


What size wire would you use on a 30amp breaker?

AWG # 10 wire.


What wire size for 400 amp service neutral size?

You need to look at the regulations that apply in your country. If in doubt, use a neutral wire of the same size as the live wire or wires.


How to calculate the best wire size to use with a 10-32 UNF-2A thread?

10-32 unf-2a <<>> The wire size does not need to be calculated. Use a wire terminal end that crimps to the wire. These terminal end come in various wire sizes and bolt hole sizes. Pick the correct end for the wire size you are using and then in that wire size range, pick the correct bolt hole size that fits the bolt.


How do you change the thermostat on a Chevrolet Impala?

Drain the radiator into a suitable container. Remove the top radiator hose at the engine. That is the thermostat housing. Remove the 2 bolts and remove the thermostat. Clean the thermostat housing and the intake manifold and install the thermostat. It is not necessary to use silicone sealer but if you feel you must then use sparingly.


How can i change the Engine Coolant Temp Sensor in my 89 olds?

it is located near the end of top radiator hose and thermostat. unplug the two wire connector, and use a 3/4" deep well socket to and to install new. Be Blessed


What size of electrical wire need to pass 50A?

Use AWG #6 wire.


What size wire would you use to wire a motor that draws 16A from a circuit?

12