The weight will depend on the material it is made of, and can be calculated if you know the density of that material. Without this additional information, this question cannot be answered.
gear with shaft dia40mm length 230 teeth 14 shaft dia 25mm width 6.5mm length 168mm
Dia X Dia X length X 7.8 / 1000000
On a ships propeller shaft, the thrust will be in line with the axis of the shaft.
An angle shaft is an enriched angle bead, with a capital, base, or both.
the th 350 was made with 3 lengths, 6 inch, 9 inch, and 12 inch(12 inch station wagon only)
Area x length x density of the material = weight
You cannot. The mass depends on the material of the shaft and that has not been specified.
gear with shaft dia40mm length 230 teeth 14 shaft dia 25mm width 6.5mm length 168mm
The swing weight will depend on the weight of shaft, length of shaft, lie angle and weight of grip. Your best bet to determine the SW is to bring it to a club builder/store and have it measured.
The formula for calculating weight of a solid shaft is dia x dia x length x 7.8 x 1000000. This formula is the most commonly used.
Dia X Dia X length X 7.8 / 1000000
Without knowledge of the material you cannot.
there is really no difference except woods are like not as powerful as the driver but the woods can be hit in the fairway not the driver
Weight Cal Weight= 3.14/4 x d x d x l x density of material d= dia of Shaft l= length of shaft Pravin
http://www.clubmaker.net/golf_club_length_specs.htm This will answer your question
Weight savings.
you dont! if you need that then you are buying a new cv shaft.