0
8square mm wire by youthbala
Wiki User
∙ 11y ago
Add your answer:
Earn +20 pts
Can 14-2 wire on a patio post be covered with white conduit?
Yes, that is fine as long as the wire does not run underground. If it does run underground you need 14-2U wire.
Do you need to run a wire to play xbox360 online with friends?
no
How do you install 1 wire alternator 1969 Mustang 351W?
If you have a new alternator its as simple as run the one wire to the solenoid. If you are converting the alternator to a one wire, you will need an external regulator. If you have a new alternator its as simple as run the one wire to the solenoid. If you are converting the alternator to a one wire, you will need an external regulator.
How does length of run affect the wire gauge to be used?
The longer the run, the bigger and heavier the wire will need to be. The AWG number denotes the diameter of the wire: the smaller the AWG number, the bigger the diameter.
How many amps per phase will you get on 7kw?
9
What size wire do you need for 440 three phase welder on an eight foot run?
The wire size depends on the amperage, not the voltage. The fact that the welder runs on 440 volts does not affect the wire size! You need to ask this question instead: What size wire do you need for a three phase welder on an eight foot run if the nameplate amps are 45A?
How do you wire a 1979 Chevy 350 hei distributor?
You need to run a switched, full-voltage wire to the "bat" terminal.
What size wire for 72 amp motor?
You will need AWG #3 if it is a short run.
Where does the fabric coated resistance wire attach inside the car if you are converting from points to a HEI system and need to replace resistance wire with 12 gauge stranded wire?
eliminate the resistor wire all together but you want to run a new larger 12 gauge wire into the same circuit , in order to do that you need to take the fuse box down inside the car and you will see where that resistor wire ties into a big wire in the fusebox, it comes from the ignition switch, you need to tie into that big wire with your 12 gauge wire that you have run from the HEI.
How do you put a engine start button?
CHECK YOUR WIRING DIAGRAMS TO BE SURE YOU DON'T NEED A RELAY. Make sure your switch can handle the amperage on the starter circuit!!! Buy a multimeter (if you don't have one). Put it on Volts DC. Go to the back of your ignition switch. Find the constant 12 volt wire (always hot). Turn the key to accessory and find which wire now has power (this is your accessory). Turn the key to "on" and find which wire has power now (this is your ignition wire). Only one wire should be left, this is your starter wire. Now disconnect the battery To start with key Tap into the ignition wire and run a wire to the POWER terminal on the switch Tap into the starter wire and run another wire to the ACC side of the switch To start without the key Tap into the always hot wire and run a wire to the POWER terminal on the switch Tap into the starter wire and run another wire to the ACC side of the switch If your button is illuminated, you will also need to run a ground wire to the switch CHECK YOUR WIRING DIAGRAMS TO BE SURE YOU DONT NEED A RELAY.
Can you use a phone wire to run xbox360 live?
No. You need Broadband Internet and a Ethernet cord.
What gauge wire do you need to run a 30 amp circuit 100 feet?
8 ga
