1 # 10 hot
1 # 12 neutral
1#12 ground
Yes you can. If you don't need 120 volts at the saw then you can use 2Conductor # 10 copper wire. FYI, don't know if you know it, but you don't count the bare ground wire in the conductor count. Anyways With # 10 wire you will get a 6 volt drop at the end of 250 feet which is 2.5% leaving you a working voltage of 234 volts.
#10 cable is no good for 120 amps, you need #2 cable, and it can be used at a distance of 250 ft.
For a 5% volt drop of 6 volts the total resistance should be less than 6/8 ohms, 0.75 ohms, which for a total wire run of 500 ft is equivalent to 1.5 ohms per 1000 ft. Wire tables show that a #10 cable should be used. A #12 cable would give a volt drop of 5.3% which would probably be acceptable for occasional use and easier to store.
That would be a 40 amp 220v circuit. Circuit breaker is 40 amps and wire is 8 awg. Should use solid copper wire. Follow oven installation instructions.
Stranded wire is the choice as you have tight bends and a short run, solid wire isn't very good in this format.
Yes you can. If you don't need 120 volts at the saw then you can use 2Conductor # 10 copper wire. FYI, don't know if you know it, but you don't count the bare ground wire in the conductor count. Anyways With # 10 wire you will get a 6 volt drop at the end of 250 feet which is 2.5% leaving you a working voltage of 234 volts.
#10 cable is no good for 120 amps, you need #2 cable, and it can be used at a distance of 250 ft.
For a 5% volt drop of 6 volts the total resistance should be less than 6/8 ohms, 0.75 ohms, which for a total wire run of 500 ft is equivalent to 1.5 ohms per 1000 ft. Wire tables show that a #10 cable should be used. A #12 cable would give a volt drop of 5.3% which would probably be acceptable for occasional use and easier to store.
If you use 250 or 300 MCM wire you will need a 2 1/2" weather head. If you use 300 MCM wire then you will need a 3" weather head.
He tried to hop over the wire, but he caught his foot and tripped.
14-3 Is the standard wire use for residental smoke detectors.
no
Use PVC pipe
That would be a 40 amp 220v circuit. Circuit breaker is 40 amps and wire is 8 awg. Should use solid copper wire. Follow oven installation instructions.
No. You need Broadband Internet and a Ethernet cord.
Stranded wire is the choice as you have tight bends and a short run, solid wire isn't very good in this format.
A #4 copper or #3 aluminium conductor will limit the voltage drop to 3% or less when supplying 30 amps for 150 feet on a 120 volt system.