0
Want this question answered?
Be notified when an answer is posted
Add your answer:
Earn +20 pts
What amount of water comes out of a hose in 1 hour with normal preasure?
"Normal Pressure" varies depending on where you live. Most municipalities try to provide water between 40 and 80 psi. That's a pretty big range. How much water comes out of your garden hose varies depending on your service pressure, the length of hose, how much water your using in your house at that moment, and where the hose is located in relation to your water service. The most accurate way for you to figure it out is to take a 5 gallon bucket (the orange Home Depot buckets are about 5 gals) and time how long it takes you to fill it. If it takes 1 minute to fill 5 gallons then you're only getting a flow rate of 5 gallons per minute (this would be uncommonly slow). If it takes 30 seconds, then you're at 10 gpm. 20 seconds -> 15 gpm, etc. If you don't need to be terribly accurate, it's pretty safe to assume somewhere between 15 to 30 gpm for normal residential service. 15 gpm is on the lame end and 30 gpm would be pretty impressive for a garden hose.
If a bathtub of 80 gallons of water is emptied in 5 minutes 20 seconds how many gallons per minuter does the bathtub drain?
QF = V / t = 80 gal / 16/3 min = 15 GPM<-----------------------------
How would you get 80 from 8?
The operation to get from 80 to 8 is division. Divide 80 by ten, and the answer is 8.
What is 7 and 29 over 80 as a decimal?
7 and 29 over 80 as a decimal would be7.29over 80
What sign would I use for you fulfilled less than 80 percent?
< 80%
How many gpm will flow through a 1 pipe at 80 psi?
-39
What would the flow rate be for a 2 inch copper pipe at 95 PSI?
80 gpm
What is the maximum water flow through a 3 inch fire hose?
To find the maximum flow you would need to know the maximum pressure. A typical fire nozzle pressure would be up to 100 psi with a diameter of 1 to 1.25 inches. The GPM would be between 300 GPM and 460 GPM through the nozzle. If it were simply a 3-inch pipe with an oversized pump, running at 100 psi with no nozzle, you could (in theory) move over 3,000 GPM through the pipe (ignoring friction loss). Even at 80 psi, a master stream through a 2-inch nozzle moves over 1,000 GPM.
What should the oil pressure be in a 1986 Mercury Grand Marquis?
40-80 PSI cold.20-40 PSI hot.40-80 PSI cold.20-40 PSI hot.
What is the tire pressure for 26570R16?
That will depend on the application and weight rating of the tire. A passenger car tire would be about 35 psi. A truck tire would be 80 psi.
What is normal Oil pressure on 1984 Oldsmobile silhoutte?
Over 20 psi at idleUnder 80 psi while driving Over 20 psi at idleUnder 80 psi while driving
Which is the oil pressure of camaro z2897 5.7 engine?
between 20 and 80 psi between 20 and 80 psi
What is the oil pressure gauge suppose to read on a 1999 covette 40 or 80 psi?
Around 80 psi cold at startup, and 40 psi at normal operating temperature.
What should compression psi be in a Gm 454 big block?
Mine had about 80-110 psi
1998 Lincoln mark viii suspension what is the psi?
I have a '94 and it is about 80 PSI. I imagine the '98 is similar.
What should your home water pressure gauge read?
8 PSI min - 80 PSI max
What psi is considered a high pressure pneumatic system?
factory air pressure norm is 80 psi
