answersLogoWhite

0

D, In California an unfused disconnect switch shall be installed within sight of any grounding rod as per NEC code for the following reasons: A) To definatively locate the grounding rod, B) To allow for service including troubleshooting, removal for cleaning and/or replacement of a defective grounding rod during periods of unstable atmospheric activity.

User Avatar

Wiki User

16y ago

What else can I help you with?

Related Questions

When inspecting an air conditioner in many areas an exterior electrical disconnect is required in sight of the?

condensing unit, elecric panel, electrical service enterance, grounding rod


Before inspecting any electrical components or wiring you should?

Before inspecting any electrical components or wiring you should disconnect the circuit from the power source.


Can you move into an apartment without inspecting it first?

According to the National electrical code book 2008 you are not allowed to move into an apartment that has not been electrical and health inspected. Sure, but if there is no check-in sheet, you will be liable for any damage when you move out. And do you want to move into a place without inspecting it first? Who knows how bad it could be.


What are the safety considerations to keep in mind when inspecting and maintaining basement electrical wiring?

When inspecting and maintaining basement electrical wiring, it is important to consider safety precautions such as turning off the power supply, using insulated tools, wearing protective gear, and checking for signs of damage or wear on the wiring. It is also important to follow proper procedures and consult a professional if needed to ensure safety and prevent electrical hazards.


What can I do electrical short of my comercialtruck?

You can try to track the problem by inspecting the wires using a test meter or take it to a repair shop for diagnostic test.


What are the common issues to look out for when inspecting a general electric panel?

When inspecting a general electric panel, common issues to look out for include loose connections, corrosion, overheating, and outdated components. These issues can lead to electrical hazards and should be addressed promptly by a qualified electrician.


What is electrical checks?

The term electrical checks will differ with respect to the machine or system being referenced. Electrical checks on a car will include the DC battery Voltage, charging voltage and current and may be voltage during engine starting. On a machine it could be main voltage secondary control voltages and even specific test point voltages on a control board.


What are the safety measures to prevent electrical knockouts in a residential setting?

To prevent electrical knockouts in a residential setting, safety measures include installing knockout seals or covers on unused openings in electrical boxes, ensuring all electrical boxes are securely fastened to the wall or ceiling, and regularly inspecting and maintaining electrical systems to identify and address any potential issues.


What is the starting salary for electrical technician?

require minimum wages for crane technician, person dismantling lifting equipment, inspecting lifting equipment, delivery vehicle driver


Where is fuse for ac switch?

The fuse for the AC switch is typically located in the electrical panel or circuit breaker box of your home. It may be labeled specifically for the air conditioning unit or HVAC system. In some cases, there may also be a disconnect switch near the outdoor unit that contains a fuse. Always ensure to turn off the power before inspecting or replacing any fuses.


What precautions should be taken to prevent electrical overloads and ensure the safety of the circuit?

To prevent electrical overloads and ensure circuit safety, precautions such as using the correct fuse or circuit breaker, avoiding daisy-chaining power strips, not overloading outlets, and regularly inspecting and maintaining electrical equipment should be taken.


What should you check for when inspecting converter dolly?

what should you check for when inspecting the coverter dolly?