Want this question answered?
12 second rule
About 102.67 feet per second. 70 miles / 1 hour = x feet / 1 second 70 miles / 3600 seconds = x feet / 1 second 369600 feet / 3600 seconds = x 102.67 = x
Divide the mph by 60. 1hr = 60 sec. If I drive 40 miles in one hour that would be .6666666667 miles in one second.
One mile per minute = 60 miles per hour = 88 ft per second
One tenth mile per second.One tenth mile per second.One tenth mile per second.One tenth mile per second.
top to bottom
Top, middle, then bottom!
Your Ford Explorer will only drive after putting it in drive and letting it warm up because it has a mechanical problem.
That would depend on certain variables, such as whether you were putting it on the same cable as the other drive. In IDE, you must have a Master drive on each channel. The second drive must be set to Slave. You were not clear in which drive you could not change the jumper. Assuming the drive in the computer is alone on the cable, it is set to Master, so your new drive must be either set to Slave and be placed on the same cable, or set as Master and placed on another cable.
Generally, you would need to set up the drive. It starts with partitioning the drive, putting a file-system on it, and then putting data on it, perhaps data recovered from the old drive or the backups. It is was the primary drive, the OS would need to be installed.
It doesn't have to cost anything. There are multiple ways on the internet to fix RROD like polishing the hard drive or unplugging the whole console (every plug in it) and then putting them all back in.
Drive it
for putting floppy disks in it
Drive.
The second drive.....
no
Putting it in the microwave, then turning it on.