answersLogoWhite

0


Best Answer

find your electric Meter and you've found the point of entry, or depending on where the electric meter is in the building, you can trace the cable back from the meter to the point of entry.

User Avatar

Wiki User

14y ago
This answer is:
User Avatar

Add your answer:

Earn +20 pts
Q: Where does the supply authorities cable enter a building?
Write your answer...
Submit
Still have questions?
magnify glass
imp
Continue Learning about Engineering

What do the engineers do in command and conquer red alert ps1?

Engineers can be used to capture enemy buildings - if the building is in green or yellow health, an engineer can enter it to damage it further. If it is on red, then the building will be captured. Also, they can be used to repair your own buildings. Each of these 'uses up' the engineer, it is lost to you.


Purpose of electrical drip loop?

On an overhead service, during periods of rain, water will run along the overhead service wires. Water would run in to the service riser and in to the top of the meter, the drip loop allows the water to drip off of the conductors instead of running in to the meter.


What is the function of a jacket in a jacketed autoclave?

It surrounds the chamber of the sterilizer, separated from the chamber by about 3 inches. It allows steam to continuously circulate in this space, also maintaining a supply of steam ready to enter the chamber immediately.


What are plumbing drain vents?

Plumbing drain vents equalize the pressure in drain piping in order to preserve trap seals on plumbing fixtures. Blocked or improperly sized vents can cause traps to dry allowing sewer gases to enter the building.


How do you determine which windings are field on a series DC motor?

Both the supply wires that enter a series motor is the field windings the field is split in two and is connected at the split to the brushes that is connected to the commentator of the armature, so the current pass thru the first half of the field then thru the armature and then thru the other half of the field. With a parallel DC motor the two fields is in series and the two wires is connected to the brushes so is the supply.