The Single Module Engine Controller (SMEC) or Single Board Engine Controller (SBEC)is located on the left inner fender panel behind the battery. Remove the battery cables and remove the battery (negative cable first, of course). The air intake for the engine passes over and cools the module. Disconnect the intake duct at the module. Now remove the screw that secures the wiring harness to the module and carefully remove the harness by pulling straight out. Finally, you can unbolt and remove the module from the fender panel. In Nov, 2002, I purchased a module from a salvage yard in Avon, MN, Martini Auto Parts. Costs $55.00 including shipping. Module worked fine. Martini sold a good product at a fair price and shipped it when they said they would. Would do business with them again. I hope this helps you. Eddie, Lubbock, TX
a diagram for a 1991 dodge dynasty w a 6 cylinder 3point 3 liter engine
in side dist under pickup coil
The 1991 Dodge Dynasty starter relay switch can be found in the fuse box. The starter relay switch will be in the third column, third from the top.
1-2-3-4-5-6
A 1994 Dodge Ram does not have a modulator.
Where is the EGR valve located on a 1995 dodge 1500 5.2 liter
the dodge/ cummins engine does not have glow plugs
first you have to install a 5.9 engine
how to install serpentine belt on a 2009 dodge journey 3.5 liter v6
The sensor will be mounted to the side of the intake manifold below the PCV valve
I have a 3.3 liter V6 and my water pump is located on the engine block just below the A/C compressor motor. It is also about 4 inches to the left of the oil filter and it has a rubber hose attached to it. Gary from Princeton, MN
The coolant temp sensor is located next the the thermostat housing.