Best Answer

135 back and 246 front for both the 2.5L and 2.3L

User Avatar

Wiki User

βˆ™ 2009-06-09 02:24:08
This answer is:
User Avatar
Study guides

Add your answer:

Earn +20 pts
Q: Where is the piston order number for Mazda millenia 95 135 back 246 front 0r 123 456?
Write your answer...
Still have questions?
magnify glass
Related questions

Where is the number 4 COIL on the Mazda millenia 2.3L engine?

left(front) bank. middle coil(2-4-6)

How do you know which piston is number one on a Mazda 1988 b2200?

It's the one closest to the crankshaft pulley, or the front of the engine, the front of the truck. Assuming it's an inline engine, not a v.

Where is the AC Condenser Fan relay located on a 2002 Mazda Millenia?

passenger side front by windshied washer reservoir

Number one piston on 1971 super beetle?

It's the front (front of the engine is front of the car) piston on the right side of the engine.

Which number oxygen sensor is the front left sensor in a 95 Mazda Millenia 2.5L?

it has 4 o2 sensors #1 cylinder is sensor 1 or bank 1 sensorType your answer here...

How do you remove the inside panel on the driver's side front door of a 98 Mazda Millenia?

Where is the oil dip stick on a 1996 Mazda millenia?

Right side of the engine comp. at the front of the engine by the belts yellow dipstick

Where is the number 1 piston located on a 1973 volkswagen beetle?

Driver side, front piston.

What type of rear brakes are on a 2002 Mazda Millenia?

The front and rear brakes are both made of ceramic. i bought front and rear brakes on eBay for $80 total.

Where is the no1 piston located at is it upfront or back close to the fire wall in a 1987b2200 Mazda truck with a carburetor?

the #1 piston will be the one closest to the front of the truck.nearest to the radiator!

Where is the sensor that reads outside temperature on 2001 Mazda millenia?

It is on the dash in front of the steering wheel,it looks like a small black bump.

How do you replace front wheel bearing on Mazda millenia s?

you gotta pull off the knuckle, and have the bearing pressed out, and a new one pressed in

People also asked