You are probably measuring between the one leg of the 240 volts and the neutral or the ground pin connection. Take the measurement from the two outside blade holes on the receptacle. There the reading should be 230 to 240 volts. Between either of the outside blade holes and the neutral or ground you should read around 120 volts.
There is no requirement on the distance the dryer must be from a sink. Any 120 volt outlet must be GFCI protected if it is within 6 feet of a sink. There is no requirement for a 240 volt dryer outlet. I would not want the dryer right next to the sink and I would want the dryer to be on a 4 wire circuit and not a 3 wire circuit. Use common sense here.
On a 240 volt outlet, such as a dryer outlet: G is Ground, W is Neutral, X and Y are the two Hot legs.
The formula you are looking for is I = W/E. W = kW x 1000.
On a 240 volt outlet, such as a dryer outlet: G is Ground, W is Neutral, X and Y are the two Hot legs.
On a 3 wire dryer cord there is no green wire. The white wire coming from the outlet is connected to ground or the green screw. The black and red wires are the hot wires.
Yes - a hair-dryer rated at 120 volts will work in a 110 volt outlet.
in a power outlet
Have the outlet changed to match the configuration of the dryer plug.
You cannot change the oil because there is no oil crankcase on a 123V Jacobsen engine. This engine is not a typical 4 cycle with a oil in the crank case. The 123V is a 2 cycle and therefore uses a oil & gas mixture. Lubrication is obtained by the fuel & oil mixture. The 123V depending on the year of manufacture is rated 4-4.2 HP.
with electric
Because a toaster does not pull near the current that a cloths dryer does.
Because a toaster does not pull near the current that a cloths dryer does.
I have the same question, especially if the outlet was a heavy duty vending machine outlet. After I plugged a hair dryer into it, something went wrong. I recovered, but my health hasn't been the same.
Yes. The outlet on the stove should be rated to 15A 110V.
Usually a stackable washer and dryer system will need a special outlet. Dryers usually run on a 220 outlet so they will need a special outlet installed where you plan to place your washer and dryer.
You bet it will.
Yes, you can.