Any more than four 90 degree bents (equaling up to 360 degrees) or a combination of other bends will make it quite difficult to pull the wires into that pipe.
This is why the electrical code prohibits more than 360 degrees. If you have to put more bends than that, place a junction box on the line after the first 360 degrees. This way you pull to the junction box and then use that junction box so continue the rest of the way.
4 quarter bend
no you cannot if you try to bend it it will snap
The 'Stub-up', or 90º bend, Back to Back Bends, Three Bend Saddles, and offset bends.
Answer for USA, Canada and countries running a 60 Hz supply service.A total of 360 degrees between openings, regardless of distance, is the NEC's limitation. From experience I know that any time you go beyond 270 degrees you are going to have a difficult pull regardless of what other steps you take.360 degrees = 4 - 90 degree bends270 degrees = 3 - 90 degree bendsAs always, if you are in doubt about what to do, the best advice anyone should give you is to call a licensed electrician to advise what work is needed.Before you do any work yourself,on electrical circuits, equipment or appliances,always use a test meter to ensure the circuit is, in fact, de-energized.IF YOU ARE NOT ALREADY SURE YOU CAN DO THIS JOBSAFELY AND COMPETENTLYREFER THIS WORK TO QUALIFIED PROFESSIONALS.
A magnet or electromagnet.
No you can not.
itcan bend it all the way or 80 degrees
yes
Craig mack, 1000 degrees
Rainy 37 Degrees
right angles (90 degrees)
The Pit River near Big Bend, CA.
it is 75 degrees Celsius
About nine.
4 quarter bend
Up to about 180-200 F degrees before it starts to bend or soften
go to youtube and watch t-pain's video for the g5 remix; you bend your knees and put your arms out like an airplane, then bend them to be 90 degrees and you go back and forth.