answersLogoWhite

0

have your oxygen sensor checked or replaced. we had the same issue on ours and replacing the o2 sensor fixed the problem

User Avatar

Wiki User

18y ago

What else can I help you with?

Related Questions

What are the release dates for HBO First Look - 1992 Driven 8-3?

HBO First Look - 1992 Driven 8-3 was released on: USA: April 2001


Remove crank bolt on a 1992 Nissan Pathfiner?

Use an air driven impact wrench.........


Why does a 1992 Pontiac Bonneviile SSEI stall everytime you make a right turn?

Carbarator is blown on right side(2 carborators).


What would cause the 1992 grand marque to stall several times on a 3 mile trip then not start?

A clogged Fuel Line


Where is the water pump on 1992 6 cylinder Dodge Spirit?

It is inside the engine, driven by the timing belt.


Why would a 1992 Ford F-150 stall when put in reverse?

could possibly be the torque convertor. wiil it go if you give it some gas going from neutral to reverse or does it still stall ? check shift linkage for pinching a wire when shifted , good luck !


What would cause a transmission of a1992 Buick lesebre to shrudder as the engine shuts down?

what will cause a transmission in a 1992 buick lasebre to shrudderas and stall engine


What turns the Distributor on a 1992 Dodge Dakota 3.9 V6?

The oil pump drive gear, which is driven by the camshaft, drives the distributor.The oil pump drive gear, which is driven by the camshaft, drives the distributor.


Why does my 1992 Buick Lesabre stop running when it gets warm after driving it for awhile and when it takes corners?

I put a new crank sensor in it, and now it runs great!


What would cause a 1992 ford e-150 to stall out when you first start it and the check engine light goes on and off?

It's probably the idle control solenoid


Why might a 1992 Buick Roadmaster 350 stall instantly with no warning at any speed or temp yet starts right back up?

CRANK SENSOR! BOB


Why will a 1992 Dodge Dakota stall when cold?

It is your Idle Airflow Censor. It is located behind your air intake manifold by two screws. Take it out and clean it off and it will fix your problem.