Why do I get lines on my converter box after it says boot
hard boot
in your boot is a switch if you look at the boot when open is a 2 part switch one part in the boot and the other in the boot lid the switch conects when you close the lid on my ka it works the brake lite hi vise boot switch and rear wiper motor very bad designe i had to replace it or make a new wireing loom and do away with the switch hope this helps george
the boot release is in the middle of the boot, you push the handle not pull
Italy is in the shape of a boot A boot. Italy is in the shape of a boot.. lol jk is not thank mr skeltal
in the boot
1. Switch ON the computer. 2. Press F2 3. Select the drive you're using to boot.
Just turn it on with the power switch.
There is a switch covered with rubber on the door post. depress the switch boot, if a resistance is not felt the switch fell away and is behind the panel. sometimes when the seatbelt is about this area when the door is closed the seatbelt will push the switch away. use a 8 or 9mm socket to remove the rubber boot. remove the panel and attach the switch to the boot. replace the panel and secure the rubber boot. make sure there is resistance when pushing in the switch.
If the computer is off the boot is called a cold boot or initial startup.If the computer is on the boot is called a warm boot or restart.
The boot light must be staying on.Check the switch.
the power steering is leaking were the lines run inside the boot on the driver side
A hard boot, or cold boot, involves turning on the power with the on/off switch, A soft boot, or warm boot, involves using the operating system to reboot.