Want this question answered?
Unknown
the answer is 3
62,105,263 households.
1 US cable equals 720 feet. 1 British cable equals 608 feet. A cable is a nautical unit of measure equal to one tenth of a nautical mile.
Simply work out the area of a section of cable.........
Unknown
You can select the cable length in the option box.
The function of cable select jumper setting is to let the cable select which drive takes priority ("master") and which one comes after ("slave").
cuz' stone cold said so!
according to use
Master.
Answer: When using an 80-conductor cable-select cable, the drive nearest the motherboard is the master, and the drive farthest from the motherboard is the slave. You can recognize a cable-select cable by a small hole somewhere in the the data cable or by labels (master or slave) on the connectors. -CompTIA A+ Guide to Hardware, Managing, Maintaining, and Troubleshooting Fifth Edition 2010 copyright - Jean Andrews, Ph.D.
Yes you can. Just connect it to the cable box, and set it up correctly.
the cable is not inserted correctly
This is a question from the A+ test!!!!!! The answer is that the cable is reversed at one end. The cable must be plugged in correctly at both the ends. The red wire on the cable shows the pin 1 end of the connector and must be plugged in correctly on the MB and the drive.
Fiber optic cable is primarily used for networking within a single building.
Always disconnect the negative cable first. When reconnecting always connect the positive cable first.