0
Why is oil applied to the surface of the oilstane when honing an edge?
Wiki User
∙ 9y agoWant this question answered?
Be notified when an answer is posted
Add your answer:
Earn +20 pts
What solid has 1 vertex and 1 edge and one surface circle?
There is no solid that has those characteristics. To have an edge it must have another surface.
If the surface area of a cube is 150 in squared what is the length of an edge?
The edge length is 5 inches.
What is a length of an edge of a cube if the surface area is 294cm squared?
The length of the edge is 7 cm
What are the three parts of a cube?
edge, surface and volume..?
What is the surface area of a cube if it has an edge of 5?
150
What actors and actresses appeared in Honing the Edge - 2003?
The cast of Honing the Edge - 2003 includes: Todd Licea as Man
What are the release dates for Honing the Edge - 2003?
Honing the Edge - 2003 was released on: USA: June 2003 (Seattle International Film Festival)
Can you hone slate flooring?
To remove scratches or stains, slate may be sanded. "Honing" is generally connected with aligning the platelets of an edge, as in a knife or razor edge.
Why can't you fall of the edge surface of earth?
why cant you fall of the edge surface of the earth
What solid has 1 vertex and 1 edge and one surface circle?
There is no solid that has those characteristics. To have an edge it must have another surface.
What is the surface area of a cube whose edge is 23.0 centimeters with a possible error of 0.0004 centimeters?
The surface area of a cube with edge 23±0.0004 cm is 3174±0.11 cm.The surface area is edge squared times 6. The surface area at 23.0004 is 3174.1104. The surface area at 22.9996 is 2173.8896.
Does Gordon Ramsey use his honing steel incorrectly?
No, nor do most TV chefs. A honing steel is not used to sharpen a blade but rather hone it. When a blade is sharpened on a whet-stone it generates a microscopically uneven edge that looks like it's serrated (under a microscope). When a chef uses a knife he or she causes these micro serrations to fold over. If you put your hands together in the traditional western prayer format, this is like the edge of a knife, if you then push your fingertips through each other and fold them over slightly this looks like what happens to the edge of the knife; ie: the micro-serrations bend over and the knife becomes less sharp. A honing steel straightens these serrations back to the way they were and hence the knife becomes sharper once again. However, for safety reasons the honing steel should be held by the handle with the steel hanging down, not up as most chefs do. If you hold it downwards the cutting edge is always pointing away from the user's body; if you hold the steel point upwards the cutting edge is always travelling towards the users body: not a good idea!
What is the correct name of a trim board that is normally applied to the lower edge of a sloping roof before the application of the surface material?
I am going to guess that you are talking about the fascia board which is usually a 2x6 board
What is the surface area of a cube that has a edge of 16inches?
The surface area would be 1536in2
What is the surface area of cube that is 8.2 cm on an edge?
The surface area is 403.44cm2
What is the surface area of a cube with an edge length of 5 inches?
The surface area of a cube with an edge length of 5 inches is 150 square inches.
The surface area of a cube as a function of the length of an edge?
Area = 6s2 where s is the length of an edge.
