0
Why should measurement be started at the end of the meterstick?
Wiki User
∙ 11y agoWant this question answered?
Be notified when an answer is posted
Add your answer:
Earn +20 pts
What is line standard and end standard?
line measurement- distance between two lines end measurement- distance between two faces
How do you measure on a tape measure?
To measure (for example) a 2 metre long plank of wood: Place the tang at one end of the plank, stretch out the tape along the plank's length, read off the measurement at the other end of the plank. In our example, the tape should read 2 metres.
What is estimated length?
An estimate is an approximate calculation or judgment of the value, number, quantity, or extent of something. Length is the measurement or extent of something from end to end.
How do you find the center point of lumber?
-- Measure the length of the piece. -- Using a pencil, write the measurement on paper. -- Using skills taught in elementary school, divide the measurement by 2 . (Alternatively, multiply the measurement by 0.5 .) -- Using the result of your calculation, measure that length from either end of the piece.
How do measure the length of an object with a ruler?
A ruler (some say it should be called a rule!) is marked along an edge with (nowadays) centimetres and millimetres. Place the zero mark on the ruler at the start of the object to be measured, and read off the measurement at the other end of the object.
Why is it better to align the meterstick with edge of the object at the 1 cm mark rather than at the end of the stick?
meter sticks give precise measurements and in order to get the full precise answer you should start where the numbers start at on the meter stick.
What is line standard and end standard?
line measurement- distance between two lines end measurement- distance between two faces
What word means end to end or on end?
The word is length. It means the measurement of something from end to end.
When did the whole African Americans Should Be Treated Unfairly thing start and end?
started since time immemorial and has yet to end.
What is meant by fitting allowance?
The fitting allowance is the difference: (pipe end to fitting center measurement) minus (pipe end to end measurement). It is the amount of length the fitting adds to the end of the pipe (to get the center of the turn).
If the retention rate in July is 90 percent what is the annualized percentage rate of retention?
Retention rate should not be annualized like turnover. Retention is based on specific individuals for a specific measurement period, i.e.Retention should being calculated as indicated below: # of Associates remaining Active at the end of the measurement period that were Active at the beginning of the measurement period/ # of Associates at the beginning of the measurement period. **The actual Associate that was employed as of the first day of the measurement period is taken into account not the number of hires that may have been termed during the measurement period.
How do I know if a Ranger 410 shotgunis 3 inch or 2 and three quarter?
It should be stamped/marked on the side of the barrel-receiver end. If not, take it to a gunsmith for measurement.
When do you get your period when you have started the pill?
At the end of the three weeks of pills, there should also be a week of different colored pills, that's when you get it.
What is the definition and example of direct measurement?
direct measurement is when you get the answer to your data straight from the experiment rather than calculating numbers in order to receive your answer in the end.
What was the measurement called the measrured the distance from the elbow the the end of the middle finger?
CUBIT
When did the American revalutionary war end?
it started at 1770 no it started at 1775
What isnthe definition of length?
The measurement or extent of something from end to end; the greater of two or the greatest of three dimensions of a body.
