Go to this site http://www.generatorjoe.net/html/nemaplugs.html and tell me what configurations you have and I might be able to help you.
Answer for USA, Canada and other countries running a 60 Hz supply service.Stop! What...? Don't try to do that...!Don't make a cable with the intention of plugging a generator into an outlet in your house, it is incredibly dangerous!Power from your generator will back-feed into the power lines, posing a severe unexpected shock hazard to any line-workers who may be fixing the lines - the very same reason you are wanting to use your generator!Plug your appliances directly into the outlets on your generator. If you want to power the outlets in your house from the generator you must do it right and install a proper 'generator transfer switch' at the main incoming breaker panel which is situated where the main electricity service cable comes into your house.As always, if you are in doubt about what to do, the best advice anyone should give you is to call a licensed electrician to advise what work is needed.IF YOU ARE NOT ALREADY SURE YOU CAN DO THIS JOBSAFELY AND COMPETENTLYREFER THIS WORK TO QUALIFIED PROFESSIONALS.
A NEMA 5-20 plug is a standard 3 prong plug. It wires the same as a NEMA 5-15 plug (Ground wire to the "D" contact, Hot to vertical terminal and neutral to the horizontal terminal (with the Ground terminal either at the top or bottom)).A 5-20P plug has the neutral blade rotated 90°. The 5-20R receptacle usually has a T-shaped neutral hole, to accept both 5-15P and 5-20P plugs.
start generator, plug in variable speed drill, set drill to forward, squeeze trigger, quickly spin drill in reverse by hand. be sure generator main breaker is on.
On a 240 volt outlet, such as a dryer outlet: G is Ground, W is Neutral, X and Y are the two Hot legs.
If you are refering to a wall receptacle, the one on the right is the hot side. The left side is the neutral and it's slot is larger that the hot one. The U shaped on the bottom is for the ground pin of the plug.
I,m going to bypass the generator and plug into the house for my race car trailor. Once I pull the plug from the gewnerator I will have a four prong male need to plug into a for prong female then be able to plug into a house socket.
Check Lowes and Home Depot they normally carry the adaptors
Yes, you can plug a power strip into a generator to run multiple items.
No you can not you will need to replace the plug with a 4 prong the same as the style of your oven and change your breaker to the correct Amp for your style of 4 prong plug
Answer for USA, Canada and other countries running a 60 Hz supply service.Stop! What...? Don't try to do that...!Don't make a cable with the intention of plugging a generator into an outlet in your house, it is incredibly dangerous!Power from your generator will back-feed into the power lines, posing a severe unexpected shock hazard to any line-workers who may be fixing the lines - the very same reason you are wanting to use your generator!Plug your appliances directly into the outlets on your generator. If you want to power the outlets in your house from the generator you must do it right and install a proper 'generator transfer switch' at the main incoming breaker panel which is situated where the main electricity service cable comes into your house.As always, if you are in doubt about what to do, the best advice anyone should give you is to call a licensed electrician to advise what work is needed.IF YOU ARE NOT ALREADY SURE YOU CAN DO THIS JOBSAFELY AND COMPETENTLYREFER THIS WORK TO QUALIFIED PROFESSIONALS.
Ground wire
It could be a loudspeaker polarised plug.
Need to know the amperage rating of the plug or the NEMA configuration of the plug and receptacle
No, the wide prong is neutral it is the white wire. The narrow prong is hot it is the black wire. The round prong (in a 3 wire plug) is safety ground it is the green wire.
The three prong plug incorporates a ground wire for safety. If there is a short circuit in an appliance that has a three prong plug, the current will travel back to the electrical panel and either blow the fuse to that circuit, or trip the circuit breaker to shut power down on that circuit.
usually the outlet plate covering a generator power is red.
easy. All you do is find something that is the same width as the tip of the prong. It needs to have a grippy handle and preferably sharp, yet not too sharp as you could damage to prong/socket. Make Sure The Power Is Off!!!