You have no wheel lock key now no air in your tire so to do flat tire they need key to remove tire pls help us how to release without key?

What do you have to do to dinghy tow your 2004 2 wheel drive trailblazer behind your motor home?

Remove the driveshaft. There were no manual transmission Trailblazers, so flat towing without removing the driveshaft really isn't an option.

How do you remove the front bumper cover from a Oldsmobile Alero?

there are 6 10mm bolts that hold the bumper. you will have to remove your mudcover. then there are 6 bolts on the inside of the bumper (3 on each side by the wheel) and 2 pins that hold it (by the hood release) these you pry of with a flat screwdriver. after removing these you should be able to remove the bumper

How do you install cv joints in a Ford Laser?

for starters you remove bolts from strut and wheel hub. then in the middle of the wheel hub you will see a bolt remove it. pull tension on the c.v and axle and pop it out of the gearbox with a flat head screw driver. pull out. then remove c.v of axle and replace.

Do you have to repack the wheel bearing on a 2004 Jeep Liberty if you replace the brake rotors?

No, you can remove and/or replace the front rotors on your Jeep Liberty without having to repack the wheel bearings. To remove the rotor, remove the brake caliper, and then pull the rotor straight off the wheel studs. If the rotor doesn't budge, then use an air hammer to tap the front face of the rotor adjacent to the wheel studs (the flat area of the rotor directly between the wheel studs). This will knock the rust loose and let the rotor slip off the studs. DO NOT use the air hammer on the braking [shiny] surface of the rotor!

How do you remove spark plug behind steering column on Chevy blazer?

I remove the left front tire and go thru the wheel well opening with a 3/8" drive spark plug socket and a long "wobble" extension. There is a flat spot on the steering columm, so if you turn the wheel to line that flat spot up, it helps.

Can you flat tow a 97 Buick la Sabre?

Only if you want to wreck the transmission. Even if you remove the driveshaft, flat towing is still generally not recommended for front wheel drive cars.

How do you remove a rear brake drum from a 1993 Toyota Corolla?

fully retract the brake adjuster and strike the outer side of the drum with a BIG hammerNew Answer HeadlineFor earlier models, e.g. 1989 station wagon (estate), the answer is to have the handbrake off, jack up rear wheel, remove wheel, pry off cap from wheel nut (using a flat screwdriver), remove wheel nut (remove locking pin, nut), and slide off the whole drum and the wheel bearing. No hammering is needed at all.

How do you remove the brake calipers on a Ford Falcon?

Are they drum or disc pads? Tools · Socket set or ring spanners · Flat bladed screw driver · Brake caliper compressor (super cheap stores)$20 This will help you remove disc pads # Remove wheel trim and loosen wheel nuts # Jack tire up until its off the ground and remove wheel nuts and place them into wheel trim and remove wheel. # Inspect the disc pads and rotor which are your wheel discs. # Normally you would have the wheel discs machined so they are even before you replace disc pads. # There are two bolts holding the caliper onto the wheel disc, the disc pads are located inside the caliper. # Sometimes you have remove both bolts to remove the caliper and sometimes can remove one bolt and loosen the other bolt and then use a flat bladed screw driver to lift the caliper and flip it open and then you can remove the old discs # Once you remove the old discs pads check the brake reservoir and remove brake fluid if necessary and use a brake caliper compressor inside the caliper to compress the piston until its flat and even, then you place the new disc pads into the caliper and close the caliper back over the wheel disc, you may have to tap it or wriggle it bit to get it back in place. # Once in place return the bolts and tighten, replace wheel and hand tight, lower tire and tighten, replace wheel trim and take car out and test brakes. # If you don't have a brake caliper compressor tool you may have to remove the 2 bolts and the brake fluid hose to remove caliper to place the caliper on a hard surface and tap the piston until its flat, but then replace the discs pads. # but then you will have to bleed all four brakes. Sam

Can you tow a 2007 jeep compass?

You can not flat tow a Compass with all four wheel on the ground.You can not flat tow a Compass with all four wheel on the ground.

What is flat without bumps?

flat without bumps

You have no wheel lock key now no air in your tire so to do flat tire they need key to remove tire pls help us how to release without key?

Add your answer:

How do you remove plastic clip in wheel well of 1999 Breez?

How do you replace front rotors on 1996 protege?