answersLogoWhite

0

No, there are many manufacturers and distributors who supply 8 AWG wire in multi-conductor cables in stock or custom combinations.

User Avatar

Wiki User

12y ago

What else can I help you with?

Related Questions

Putting in a new kenwood system in 05f150like to know if you should run new wires from amp or use exsiting wires IF you need to run new what gaugeand what gauge are the wires from factory system?

use the existing wires you only need to change the gauge of the wires if amp is 500+ watts if less watts there not much difference in sound quality


How do I wire a ceiling fan and light separately?

To wire a ceiling fan and light separately, you will need to run separate wires from the fan to the wall switch. Connect the fan and light to the corresponding wires in the ceiling, and then connect the separate wires to the appropriate switches on the wall. Make sure to follow the manufacturer's instructions and turn off the power before starting the wiring process.


Which kind of wires will I need to hook up my Amp?

You'll need RCA style cables to connect from your headunit to the amp. You'll then need Speaker Wire to run from the outputs of the Amp to the speaker terminals. You'll also need a heavy gauge power wire. A wiring kit such as the StreetWires Power Station PSK04Ri 4-gauge amplifier wiring kit.


How do you hook up pro tach RPM gauge on a 1982 Ford F-150 pick up?

need to know how to hook up the wires on the engine on F-150 pick up to make a pro tach rpm gauge work


What causes poor throttle control in a 2001 Ford Focus?

You probably need spark plug wires and plugs. DO NOT use a feeler gauge, you will ruin the platinum and they will NOT fire. OUT OF THE BOX AND INTO THE ENGINE!!


How to determine wires to cut at ignition switch for remote start need color for wire to starter motor and primary ignition?

It should be the yellow wire that runs from the ign. harness from the steering wheelit will be about a 12 ga wirethis wire will be with about 5-7 other wires of the same gauge.


What gauge do you need when you first get your eyebrow done?

16 gauge is standard.


2002 Pontiac Montana fuel gauge is either empty or full why?

I had this problem with my 2002 montana. The fuel gauge inside the tank was defective I went to a garage where and had the gauge changed (you can buy the part from the dealer ) You have to take the fuel tank down and unplug the wires and the fuel lines(you need a special tool to disconnect the fuel lines) Parts and labor cost me $260.00


How do you get a gas gauge unstuck from full position on a 1998 Ford Windstar GL 38L?

If the gauge is reading full (pinned as we call it) it can be a ground to the sending unit or the wire going to it is broken ,,this will cause this..Sending unit wires are on top of the tank some times you can see it (or the wires that go to it )test them there you'll need a good meter!!If you want to see what it looks like go to a parts shop and get them to show you one


How can I terminate a Cat 5 cable properly?

To terminate a Cat 5 cable properly, you will need to strip the outer jacket, separate and arrange the individual wires according to the T568A or T568B wiring standard, trim the excess wire length, and insert the wires into a modular connector. Finally, use a crimping tool to secure the wires in place.


Gas gauge and temperature gauge don't work?

you need a newvoltage reducer


How can I wire a bathroom fan and light on separate switches?

To wire a bathroom fan and light on separate switches, you will need to run separate wires from the fan and light to the switches. Connect the fan to one switch and the light to another switch. Make sure to follow proper electrical wiring guidelines and consult a professional if needed.