Wiki User
∙ 10y agohave have to divide them
Wiki User
∙ 10y agoto cut a rectangle into 3 equal parts, you make 2 lines each a little of center. adjust the line so the 3 parts are equal
To divide a rectangle into 7 parts using 3 lines: Use 2 lines to draw two diagonals. Use the third line to draw a parallel line to any of the sides but not passing through the centre. This will create 7 parts in the rectangle.
There might be a specific tool for this, but what I do is separate a line into three equal parts and (with all three parts selected) stretch them from end to end of the rectangle. Then I make two more copies of the rectangle and just stretch them into place, using the width of the original triangle and the lengths of the lines as a reference.
Divide 3 inches in 5 equal parts
two vertical at one third and two thirds the distance from a side and one horizontal in the middle (or two horizontal one vertical)
Divide it into equal parts with horizontal or vertical lines.
Select any one side and divide its length into 5 equal parts. Draw lines that are parallel to the adjacent side to the opposite side. This will divide the rectangle into 5 equal strips.
Divide one edge into five equal parts and construct lines perpendicular to that edge at those points.
to cut a rectangle into 3 equal parts, you make 2 lines each a little of center. adjust the line so the 3 parts are equal
vertical lines across the body
You divide it into parts of 1.2by4
To divide a rectangle into 7 parts using 3 lines: Use 2 lines to draw two diagonals. Use the third line to draw a parallel line to any of the sides but not passing through the centre
Might be divide it to rectangle
the answer is .....you can't .You can only divide it into 6 parts NOT 8 PARTS.
divide the rectangle into 5 equal parts. Shade two of those parts.
To divide a rectangle into 7 parts using 3 lines: Use 2 lines to draw two diagonals. Use the third line to draw a parallel line to any of the sides but not passing through the centre. This will create 7 parts in the rectangle.
There might be a specific tool for this, but what I do is separate a line into three equal parts and (with all three parts selected) stretch them from end to end of the rectangle. Then I make two more copies of the rectangle and just stretch them into place, using the width of the original triangle and the lengths of the lines as a reference.