This means one of three things: Most probable: The dash selector switch needs to be replaced. This is also the least expensive solution and easiest to fix yourself. The dash trim plate can be pulled free. Remove the switch, unplug, and replace. Also possible but less likely: The encoder motor at the front differential has gone south or the connection thereto has come loose. This is the motor that engages and disengages the front end when you use the selector switch to shift in and out of 4wd. Least likely and most expensive: Some "other" transfer case or front end problem that must be diagnosed with a code reader. Some dealers will read the code for free.
To reset service ride control light on yukon detail one must use their manual to determine which button or switch is used to reset the control light properly.
why does my service control light come on
changed battery engine light stays on
You can reset your engine service light by holding in the scroll button. Hold the button in until the engine oil life goes to 100 percent. The engine service light will go off.
Have vehicle scanned to determine the problem
To reset the "Service" light in Audi TT: With the car turned off Hold the right button on the instrument cluster Turn the key to the on position Push the left button on the instrument cluster Until the Service light goes out. (will say "Service in 10000 miles")
A reset Engine Service Light comes on when an issue comes up with in the engine. This light can be reset by a tech or by fixing the problem.
with a few button taps its not to hard with a few button taps its not to hard
If the service light is in the shape if a spanner then I presume it is like the 2008 model. In which case press and hold the trip button "0.0" before inserting the key. Insert ignition key while holding down the trip button and turn on ignition without starting car. Release the trip button and the service light spanner will cease to flash. Now turn the trip button to the right (clockwise) and it will reset. Service light (spanner) should disappear and only return when the next service is due!
On the Laguna 3 press the upper button on the right hand stalk until the service panel appears Hold the button in for several seconds and the panel will flash with the new mileage interval Release button andne service spanner light will go out Enjoy!
1) Turn key to position 2.2) Press/release the R button to show the next service due light. Release button.3) Turn key to Off.4) Press and HOLD the same R button to view the service light, THEN, within 2 seconds, turn key to position 2.5) Wait up to 10 second and the light will reset to show new service .
For the service light, Switch ignition on, The display will flash for 2 seconds, press the button next to fuel gauge until "----" appeares in the display, Release the button and switch the ignition off, and that should reset the light for you,