By the amount and size of grit on the paper. The smaller the number, the less the grit of larger size. the bigger the number, the more the grit of smaller size. 60 grit would be for removing a lot of material, 320 grit would be for finer sanding.
Floods are measured by a known level of depth. If the water level is over that depth, it may be considered a flood.
Trillions
Polls and surveys by: T'Daddy
public opinion
Such questions only work when "the following" is listed with the question.
Yes, clay does have more friction than sandpaper. This is because, clay is a much heavier object/material then sandpaper, therefore if you were to drag a lump of clay on the floor and measured the friction, it would be higher then the amount of friction caused by sandpaper. If the amount of force needed to pull the clay is larger then the amount of force needed to pull the sandpaper, that means that there is a much larger amount of friction present, because the more friction there is present, the harder you would need to pull. Hope this helps.
Sharkskin was originally used as Sandpaper. When modern manufacturing techniques came, sandpaper was mass produced.
Um...Sandpaper??I am not sure but i would prefer Sandpaper....?
Sandpaper is both helpful and harmful.
Um...Sandpaper??I am not sure but i would prefer Sandpaper....?
That is A coarse sandpaper, It is generally used before A fine sandpaper.
sandpaper, coffee maker , see you later, Kennedy kaper
Traditionally, sandpaper was made of paper impregnated with tiny crystals of quartz or garnet. The finer the particles, the smoother the sandpaper was. While that type of sandpaper is still widely available, most modern sandpaper is made with aluminum oxide, which is much longer lasting.
Aboriginal name for sandpaper fig is noo-ni.
The correct one is "coarse sandpaper".
3M sandpaper can be purchased from your local hardware store, DIY stores or online. Shops such as Bowdens or Wickes will have a large range of sandpaper available.
For pure sanding of bondo or metal, No. If you are preping to paint or sanding primer you should use Wet or Dry sandpaper and sand wet.