Check for a blown fuse
here are some: Car rear-view mirrors and side mirrors. Over-the-sink in the bathroom mirrors (for shaving and other uses) Full-length dressing mirrors, often found inside closets Dental mirrors Fun-house mirrors with wavy surfaces Mirrored balls hanging from the ceiling in discos Periscopes Auto mechanics use mirrors held on rods so they can examine hard-to-reach places. Torches have curved mirrors for directing the beam of light Searchlights, floodlights, and spotlights (used in theatres) have similar mirrors. In barbershops so that the customer may see the result, front and back to collect sunlight for solar power generation
Hollywood mirrors are more expensive than regular mirrors, for celebrities are "using" them. Go on www.amazon.com and you'll probably find two mirrors exactly the same, but with "Hollywood" typed in front of one name.
Power is work per time, joules per second. So Power would be the rate at which work can be performed.
If you use blemished mirrors, then you cannot.
;lkzdnvklsdngtklajhfgjklashtiabhnsdkjfhalskjdhvkcsajdntiuahfskljabnstkljhasdiofnaksdtjbaisuthgklajsbcvilasuhtklajsndgkljshadtilukhqaet
you might check for a blown fuse.
Yes, mirrors and also lenses. There are various patents applied for covering many schemes like this.
Look in your fuse panel on the passenger's side...it requires a 3 amp fuse and it controls both the power mirrors and cruise control. I just replaced on on my 90 Vette, now both work fine.
If it has power mirrors, the switch is on the door.
I have same problem on my truck seems that you have to replace the d.s.m. driver side module under the seat, because that controls all electric power to seat, pedals, and rear view mirrors.
I would suspect a blown fuse, since it is just a few items not working.
Power mirrors
very well could be a bad switch.
The fuse for the power mirrors on a 96 Chevy Silverado K1500 are found under the hood.
You'll have to get pigtails for the harness that attaches to the mirrors, then you will have to get the under dash power mirrors/doors harness. Then you will have to get the power mirror switch that mounts to the dash, then you will have to either run a new engine to firewall harness, or figure out the wiring (i.e. : What wires are power, ground, left, right, up, down power/grd) and wire them up to the existing harness. Basically your replacing the dash and engine harness if you want to do this. You could always just splice wires together and get it to work, but if you do that theres always a chance that the harness will overload and melt and catch fire. Good luck!
It is now 2013, and yes power folding mirrors are available.It is now 2013, and yes power folding mirrors are available.