we did this i my science class . you have to balance the nails and make sure they fit.
into a piece of wood
When a nail is hammered into wood, the force creates friction between the nail and the wood, generating heat due to the resistance. This heat is also caused by the energy from the impact and the compression of the wood fibers around the nail.
The nail presses the wood outward away from it. This compressed wood around the nail pushes back holding it in place.
The nail to balance upon must be hammered into a block of wood so it stands unaided. Next lie one of the nails flat on the table. Lie 4 of the other nails heads along the shaft of the nail so the head is just on the other side of the lying nail. Lie the other 4 nails so the heads are in between the other nails. |-_-_-_- Sort of thing. Then lay the last nail on top of this with the hed of this nail in the opposite direction of the first nail you laid down. Now gently take both ends of the "sandwich" and balance on the head of the nail in the block. The weight of the nails hanging down will make the heads of the nails grip the top nail and stay there! Che The nail to balance upon must be hammered into a block of wood so it stands unaided. Next lie one of the nails flat on the table. Lie 4 of the other nails heads along the shaft of the nail so the head is just on the other side of the lying nail. Lie the other 4 nails so the heads are in between the other nails. |-_-_-_- Sort of thing. Then lay the last nail on top of this with the hed of this nail in the opposite direction of the first nail you laid down. Now gently take both ends of the "sandwich" and balance on the head of the nail in the block. The weight of the nails hanging down will make the heads of the nails grip the top nail and stay there! Che
Board is a piece of wood cut evenly into planks of varying sizes.The man hammered a nail into the board.
A nail clincher is used when shoeing a horse. After the shoe has been hammered on, the nail clincher is used to apply pressure to fully set the nails. Finger-tightening a bolt is to a wrench like a farriers hammer is to hoof clinchers. Answer brought to you by www.everythingsintack.net
When a nail is bent when hammered, it is a physical reaction. The bending of the nail changes its shape and structure without altering its chemical composition.
The jeweled headdress that was hammered out of a nail in Christ's cross is called a circlet. It is also referred to as a caul.
Well, if you hammered a nail into pumice, the nail would probably just sink right in like a hot knife through butter. Pumice is so porous and lightweight, it wouldn't offer much resistance. Now, if you tried hammering a nail into granite, good luck with that! Granite is tough as nails (pun intended), so that nail would likely bend or break before making much of a dent.
The recommended size of nails for use with a nail gun is typically 10d nails.
Toed - to toe in, hammer a nail in on a slant.
Coil nails are made up of a series of nails arranged in a circular pattern and connected by a metal piece. These coil nails are intended for use with a nail gun. Coil nail manufacturers in India make certain that their products are made of high-quality materials. These manufacturing businesses can be found almost anywhere in the country.