0
What else can I help you with?
How do you wire fog lights in series and parallel with only one relay?
You typically do not want to wire it in series because if one bulb goes bad then the other lights will be off too. If you remember older Xmas lights, one of the bulb is burnt then the rest would tunrned off. To wire it parallel, you must splice your wires to the same amount of bulbs you are going to use. Connect all positive wire terminals to each bulb then ground the other side of bulbs. This way when one of them goes out, the others will remain lit.
How do you wire license plate lights on a gas scooter?
to wire the license plate lights you must have lights and wire them to the scooter.
How can I wire multiple lights on one circuit diagram?
To wire multiple lights on one circuit diagram, you can connect the lights in parallel by running a single wire from the power source to each light fixture. This allows each light to operate independently without affecting the others. Make sure to use the appropriate gauge wire and follow safety guidelines when wiring multiple lights on a circuit.
My tail lights and dash lights or out on my 98 corvette. cant figure out which fuse it is?
check fusible link wires connected to the starter..fusible links looks like a skinny wire that has a fatter wire in the middle...the fusible link is fat but on the inside the wire is skinny and act like a fuse which burns out once in a while...
How do you wire brake lights for Honda cbr 1000?
how do i wire my brake lights on my Honda 1000
What color is the ground wire to trailer lights?
The ground wire for trailer lights is typically white.
How will a single burned-out bulb affect the strings of lights if each light is attached to its own wire?
If by "its own wire" you mean they are connected in parallel, then one bulb won't affect the others.
How can I wire multiple lights to one switch efficiently and safely?
To wire multiple lights to one switch efficiently and safely, you can connect the lights in parallel using a junction box. Run a cable from the switch to the first light, then connect additional cables from that light to the others. Make sure to use the appropriate gauge wire for the load and follow all electrical codes and safety precautions.
What is wrong: The lights on your 300zx do not stay on-- after about 10 minute the fuse burns out regardless of many times you replace it?
i recommend checking your wires going to all your lights. look for breaks in the wire casing where it may be touching the body or arching. good luck.
Parking lights go on when brakes are apply and dashboard lights up?
short in the wire or they are all on one wire
How to wire multiple lights to one switch?
To wire multiple lights to one switch, you can connect the lights in parallel by running a cable from the switch to each light fixture. Make sure to connect the hot wire from the switch to the hot wire of each light, and the neutral wire from the switch to the neutral wire of each light. This will allow you to control all the lights with a single switch.
How does a light boble work?
A light bulb has a filament wire inside made of nichrome. When electricity is passed through this wire it lights up brightly. If this happens in air the wire burns out and breaks. To stop this, bulbs are filled with a non flammable gas called argon that allows the wire to glow without breaking because there is no oxygen inside the bulb.
