0
simple option: take a string, wrap it around the tube, cut off extra, measure the string. Divide by 3, use a ruler to mark the 3 spots on the string, wrap back around tube, and transfer the dots to the tube. DRILL!
Accurate option: find circumference of tube. (you can find this by measuring the diameter of the tube, multiply that by PI) divide by 3, mark a starting point, drill holes offset by your length.
What else can I help you with?
What is the drill size for 8-32 sti tap?
For a cut tap the correct drill size is a #17 drill, which has a diameter of .173 inches.
What is the diameter of an 8mm drill bit in inches.?
For all practical purposes an 8mm drill is equal to 5/16 inch.
What is the thinnest drill bit available for purchase?
The thinnest drill bit available for purchase is typically around 0.0135 inches in diameter, also known as a 80 drill bit.
A carpenter has a bolt with the diameter 0.3125 inchesWill the bolt fit in hole made by a drill bit with diameter 0.3 inches?
if the diameter 5/16 inches then you covert the 5/16 into 0.3125 inches. divide 5 by 16=0.3125 which is a little bigger than 0.3! ;)
What is the recommended 5 drill bit size for drilling holes in metal?
The recommended 5 drill bit size for drilling holes in metal is 0.2055 inches in diameter.
How many inches equals an 8mm drill bit?
There are 25.4 millimetres in one inch. Therefore, rounded to two decimal places, 8 millimetres is equal to 8 / 25.4 = 0.31 inches.
If you drill a hole 40 feet deep by 24 inches in diameter how much concrete will it take to fill it in?
18.6240 yd³
What size for you drill out a 0.055 to?
To drill out a hole that has a diameter of 0.055 inches, you would typically use a drill bit that is slightly larger than 0.055 inches, depending on the desired final size. If you need to increase the hole size, you can consider using a 1/16 inch (0.0625 inches) drill bit, which is a common size for this purpose. Always ensure to check the specifications for the application to avoid oversizing.
What is a number 10 drill bit?
A number 10 drill bit refers to a drill bit size in the U.S. numbering system, which is commonly used for small diameter holes. Specifically, a number 10 drill bit has a diameter of approximately 0.1935 inches (4.9 mm). It is often used in woodworking, metalworking, and for creating pilot holes for screws. The exact size can vary slightly depending on the specific drill bit manufacturer.
What is the diameter of the tap drill for a 1 inch 8 UNC threaded hole?
7/8 diameter drill or .875
What is a hand drill diameter?
A hand drill is scommonly used for holes under 1/4 in in diameterANS 2 - The diameter is simply the width of the drill bit from side to side.
What is the recommended drill size for a hole that needs to be 6mm in diameter?
The recommended drill size for a hole that needs to be 6mm in diameter is 5.5mm.
