thru HDMI
check first your satellite receiver if there is an HDMI jack. connect your HDMI cables from your satellite receiver to your tv tuner. if you don't have the HDMI jack, check the AV output jack. connect the AV cables from your satellite receiver to your tv tuner. you can use either AV or HDMI.
You will be able to connect your iPod into the Yamaha RX V365 AV and have superior sound quality.
It is used to switch audio and video signals into a television set, monitor, etc. It also contains a radio receiver and a audio power amp to drive the speakers.
You can't. You will have to use a HD cable box with an HDMI output to connect this receiver.
A Sony PlayStation 2 and a dish receiver are two video and audio sources, and cannot be directly connected to each other. You can plug both into a television that has multiple video and audio inputs, or connect them to a home theater receiver, and then connect that to your TV.
check your surround sound if it has an HDMI or AV input jacks. if it has, then you are good to go. from your satellite receiver, attach the HDMI cable or AV cable. connect it to your surround sound. after connecting the satellite receiver box and surround sound, attach the HDMI or AV cable from the surround sound to your television.
The Sony STR DH700 AV receiver has the power of 7.1 channels.
The Onkyo TX SR806 AV receiver is THX Certified Professional.
If your television has an "audio out" or "monitor out" with an audio connection you will be able to connect the television to the desired input on the av receiver. Use standard composite audio (Red and White/Black RCA) OR if the audio output on the television is digital you will need a digital coax or optical cable.
One of the best AV receivers for surround sound is a Yamaha.
You need 4 sets of twin RCA (Phono) male to 3-poles minijack. Plug the four sets of minijack to be back of the Gigaworks and 8 phono to the back of your AV receiver (Pre-Amp Out). Lime = Front L/R, Orange = Cen/Sub, Black = Rear L/R, Grey = Side L/R Alternatively, cut the phono end of the 7 speakers, which gives you two strain of wires, screw the wires to the back of the AV unit (Speaker out). And use RCA to minijack. Plug the minijack end to the Orange (Cen/Sub) at the back of your Gigaworks and the RCA to the AV Pre-Amp Out Sub. Make sure you check your AV's RMS wattage and Impendence. Otherwise you might blow your speakers.