0
Add your answer:
Earn +20 pts
Can brain shrinkage due to depression be reversed?
Brain shrinkage due to depression can be reversed. This can be done by hippocampus shrinkage.
How do you control of shrinkage lycra fabric?
I try shirting cotton lycra fabric shrinkage control but not succses why? finishing stenter m/c befor stenter -10 % shrinkage after sanforise -12% shrinkage why increase? I set shrinkage -6% to -7 % but not set ? which type of process set to control shrinkage on cotton lycra fabric.
How calculate Shrinkage percentage of rubber?
how to calculating of shrinkage a rubber parts
why shrinkage testing is important?
Shrinkage templates directly measure shrinkage without any markings and calculation errors. Shrinkage testing machine of Amith Garments comes with calibration certificate along with the user manual.
What part of speech is the word shrinkage?
The word shrinkage is a noun. The plural is shrinkages.
What is ingot shrinkage?
Due to change in density of liquid metal to solidification shrinkage occurs. Shrinkage found in top of the ingot. It is also called piping.
Shrinkage of concrete?
The loss of water results in reduction of volume of concrete this is known as shrinkage of concrete.Prevention of shrinkage in concrete:Low moisture contentSize of aggregates used.
How do you find the ratio of 152?
A ratio is a property of two or more numbers. It is not possible to find the ratio of a single number.
Why shirinkage in concerete?
Shrinkage in concrete occurs due to the loss of moisture during the curing process. As the water evaporates, the concrete material contracts and reduces in volume. This shrinkage can lead to cracks forming in the concrete if not properly controlled. Factors such as mix design, curing methods, and environmental conditions can influence the extent of shrinkage in concrete.
How do you take shrinkage report in knitted fabrics?
how to take shrinkage calculate of knit fabric
How do you find the ratio of shape?
The answer depends on the ratio of the shape to what!
Shrinkage holes appear on the workpiece working surface?
Some formed parts, even if there are shrinkage holes inside, sometimes do not hinder. As described in the beginning, shrinkage holes are easy to appear on the high-temperature side of the mold, while shrinkage holes are difficult to appear on the low-temperature side.Therefore, the surface that does not allow the shrinkage hole should be fully cooled, or on the contrary will allow the shrinkage hole (that is, does not allow the relative surface of the shrinkage hole) high temperature molding is also very effective.
