0
Want this question answered?
Be notified when an answer is posted
Add your answer:
Earn +20 pts
What is the constant rate of change if at 1 the water level is 13 inches at 130 the water is 18 inches and at 230 the water is 28 inches answer com?
It is 10" per hour.
What is difference between objectives and functions?
The objective of a water supply it to get water into houses. The function of the pipe it to carry that water and the function of a tap is to control the flow of the water.
What is the approximate percentage of the world's water to where it is stored?
liquid,salt water 97 % frozen 2 % liquid,fresh water 1 % APEX:)
How many btu's in office water-cooler?
There are no BTUs in an office water-cooler. But you can calculate how many BTUs are removed by the cooler. One BTU or British Thermal Unit is the amount of heat energy required to raise the temperature of one pound of water one degree Fahrenheit. There for when you remove one BTU you are lowering one pound of water one degree Fahrenheit. So if you know how many pounds of water you have and the temperature of the water you start with and the temperature of the water comming out of the cooler you can calculate how many BTUs the cooling unit of the water cooler has removed. BTU=Temp1 - Temp 2 X LB water
What percentage of water is in red blood cells?
there is 43% of water in the red blood cells
How do you change water pump impeller 2004 nautique?
Planetnautique.com
How do you change a water pump on a 1993 140 Johnson?
How do you change a water pump impeller on a 1993 Johnson out board
How do you change impeller on 1957 evinrude 15hp?
Where does the water port com out from noted
Chrysler outboard 10 hp not pumping water?
change impeller or check for blocks in water lines
How do you change the impeller on the water pump on your 35 horsepower evinrude outboard boat motor?
First, remove the lower unit (there is a housing for the water pump). The drive shaft goes through the housing and turns impeller. Remove the housing, the impeller is on the shaft. Install the new impeller. When replacing the housing, turn the drive shaft clockwise to make it slide down over the impeller.
What is the function of an impeller?
An impeller is used in many devices, such as a washing machine and water jet. An impeller is used to control the pressure and flow of water. It is found inside of a tube or a conduit, an impeller is a type of rotor.
How often should you change a water pump impeller in an outboard engine?
Every two years to be safe
How do you change a water impeller pump from a 115 hp Suzuki outboard?
Sprinkle liberally a vile of gypsy tears
What parts are needed to change a water impeller on 70 hp Chrysler outboard motor?
18-3085 sierra
How to change the rotation of deep well water pump?
You cannot do that. The pump impeller blades will only work one way.You cannot do that. The pump impeller blades will only work one way.
How do you change your impeller on your yanmar engine in a sailboat?
Go to the below website. It is very helpful. http://boatwizard.blogspot.com/2007/09/how-to-change-water-pump-impeller.html
Where is the impeller on a sand pump?
An impeller in a pump is the part that the motor spins that actually does the work of moving the water. Due to it's design when it spins it creates a vacuum that pulls the water in the middle of an opening on the front of the impeller and throws it to the outside where it is then channeled to the output of the pump.
