The formula you are looking for is I = W/E. Amps = Watts/Volts.
Watts= voltage times amps. So if you divide Watts by voltage, you will get amps = .33333 or about a 1/3 amp load. This is assuming a 120 volt circuit.
10000 watts / 220 volts = 45.4545 amperes
4800
volts times amps equals watts, a measure of power. Amps times hours equals amp-hours, a measure of electric charge. Electric charge times voltage is energy. So 120 volts at 10 amps for 4 hours would pass 40 amp-hours of charge, the power would be 1200 watts and the energy would be 4800 watt-hours or 4.8 kilowatt-hours. So volts times amp-hours equals energy in watt-hours.
The formula you are looking for is I = W/E. Amps = Watts/Volts.
That depends on the voltage available. We assume 120 volts. Then amperage equals power divided by voltage. Amp. = 900 watts / 120 volts = 7.5 amps.
Wrong question. I assume that this pertains to a car and not a house. All modern cars run on a 12-volt system. So what I think you meant to ask is "how many AMPS in 90 watts at 12 volts?". Watts divided by volts equals amps, so 90 watts divided by 12 volts equals 7.5 amps. If you are trying to wire in a car stereo amp, better go with a 10 amp fuse.
The Audiobahn amp A2601Q model has a maximum power output of 2600 watts.
The Alpine V12 MRV-T501 amp has a maximum power output of 500 watts.
To find the amperage, use the formula: Amps = Watts / Volts. So, for 1.5 watts at 12 volts, the amperage would be 0.125 amps.
Watts equals volts multiplied by amps. This would therefore be a five amp circuit.
120Watts=1Amp
Ohms does not equal watts. You need to know what voltage is across the resistor to determine how many watts it is drawing or how many watts the resistor should be rated for.Power is the voltage across the resistor SQUARED divided by the resistance. If this 4 ohm resistor has 12 volts across it then the watts power is (12 x 12) / 4 = 36 watts.1 Watt equals 1 Volt times 1 Amp.
The Orion CS 100.2 amp is rated for 100 watts RMS per channel at 2 ohms.
Watts = Amps x Volts x Power Factor Maximum value of PF is 1 for a resistive load. If you have 120 volts and a PF = 1, then amps = 10.
To calculate the power (in watts), use the formula P = V x I, where P is power, V is voltage, and I is current. In this case, P = 230V x 1.30A, which equals 299 watts.