A typical multimeter can measure: * AC & DC voltage (volt) * AC & DC current (amp) * resistance (ohm)
depends on your load...
what is the diference between 12V 15A DC coil & 12V 10 amps DC coil
Just consider the a DC voltage as the function y = (DC value), lets call the DC value 1 volt. Then the integral of y=1 is y=x. The op amp will create a ramp that is representative of y=x until it saturates. Depending on the op amp, it will most likely saturate somewhere around Vcc - 2V. As soon as it hits this rail it will level off.
An electrical ammeter.
You can use a DC ammeter.
No. The ammeter must be designed to measure DC. Some clamp-on ammeters are designed to measure both AC and DC.
Most volt/amp meters have a DC mode. You measure DC voltage by putting the two probes across the voltage source. You measure current by either putting the meter in series with the load or using a clamp on amp meter that measures current flow through induction.
An Ammeter is connected in series with the circuit that you want to make the measurement on.
A typical multimeter can measure: * AC & DC voltage (volt) * AC & DC current (amp) * resistance (ohm)
depends on your load...
what is the diference between 12V 15A DC coil & 12V 10 amps DC coil
The lowest amperage range on the VOM should be used to measure milliamps. To get a very accurate reading a digital VOM should be used as an analogue VOM usually loads the line that it is reading.
According to me the information about the 3 Volts DC batteries is incomplete i.e.The amp-hr capacity is not provided.If this is known then the answer would be 3X the amp-hr .
330 milli ohms
Yes but only up to a load torque of 8/9 of the rated torque.
if DC = 10 What is the measure of angle ABD?