All other things being equal, an incandescent light should not "flicker" whether it is connected to 120 or 130 VAC.
The average deep freezer or chest freezer uses about 130 watts. There are some energy saver models that might use less wattage.
There are zero watts in 130 amps. W = A x V. Without a voltage stated the wattage can not be calculated.
attack cargo plane
It depends on the local utility power company and the the neighborhood transformer taps used. It also depends on how far away the transformer is from the house. There is a voltage drop depending on the size and length of wire. It sometimes is 120v, 125v, 130v or anywhere in between. It doesn't make much difference.
I would run 1/0 gauge.
It is not recommended to use a 120 volt bulb in a 130 volt socket as it can cause the bulb to burn out faster or even lead to safety hazards. It is important to match the voltage rating of the bulb with the socket for optimal performance and safety.
It is not recommended to use a 130 volt light bulb in a 120 volt socket as it may cause the bulb to burn out prematurely or even pose a safety hazard. It is best to match the voltage rating of the bulb with the voltage of the socket to ensure proper function and safety.
No, it is not recommended to use a 130-volt bulb in a 120-volt socket as it can lead to potential safety hazards. The bulb may burn out prematurely, overheat, or cause damage to the socket and wiring. Always use the recommended voltage bulbs for your light fixtures.
Using a 120 volt bulb in a 130 volt socket may cause the bulb to burn out more quickly or not function properly. The higher voltage from the socket can lead to a higher current flowing through the bulb, which can damage it or cause it to fail prematurely. It is always best to match the voltage of the bulb with the voltage of the socket for optimal performance and safety.
Choose a bulb with the same voltage as your fixture to prevent damage or risk of overheating. If the fixture specifies 120 volts, use a 120-volt bulb. If in doubt, consult the manufacturer's instructions or a professional electrician.
Yes, in fact that is what a rough service bulb is rated at. The bulb used on a 120 volt system will have a reduced wattage output as to what it would be on 130 volts.
yes the bulb will actually last longer
Yes. The bulb will be slightly dimmer, but will last much longer. Most 145V bulbs are intended to be used in 120V exit signs. The reason for the higher voltage rating on the bulb is because it will last a long, long time when used at 120V.
You're looking at 130v light bulbs? Well...the answer is "nowhere." A 130v light bulb has a heavier-duty filament in it than a 120v bulb does, so the bulb will last longer. Put it in a regular socket and it will work fine.
Not a lot. The rating is to denote the voltage the bulb is designed for. The higher rating just says it will handle voltage that high so you have a bit more flexibility if your voltage fluctuates.
Yes, because all manufactures figure in a minimal safety factor in order to pass UL code for people who don't follow recommended applications. <<>> A 130 volt bulb will not be as bright as a comparable bulb of the same wattage on 120 volts. Traffic signal light bulbs have a 130 volt rating. Used on 120 volt systems the bulbs last much longer because that are rated for a higher voltage. This bulb will gradually be replaced by LED lamps which have a much more significant life span.
12-V a.c. is a root-mean-square value, which is exactlyequivalent to 12-V d.c., so the brightness of the lamp will be identical, regardless of whether it is connected to an a.c. or d.c. source.