If the wires are of identical materials, the 26 guage wire has more (higher) resistance.
Well I am asnwering this just because the body piercing industry uses AWG (American Wire Gauge) for a standard jewellery gauge. So 14g is thicker than 18g, the higher the number the thinner it is, the lower the number the thicker it is.
No, because the power dissipated in a resistor is proportional to the square of the current through the resistor but only directly proportional to the resistance of the resistor (I^2 * R) and the current through the lower value resistor will be higher than the current through the higher value resistor, the lower value resistor will usually dissipate more power.
A square wave will have the highest value since it has a peak, positive or negative, all of the time. Other wave shapes such as triangular and sine, have a lower value than this.
Watts is equal to volts x current x Power Factor. The maximum value of Power Factor is 1 for a resistive load. For motors and other inductive devices the Power Factor is less than 1. Your maximum wattage is 10,000 watts and decreases as Power Factor decreases.
If you are asking whether power-factor improvement has any effect on a wattmeter reading, then the answer is no, it doesn't. Improving the power factor of a load has absolutely no effect on the power of the load, but it can act to reduce the value of the load current.
12 gauge is thicker than 20 gauge. The lower the gauge, the thicker the sheet metal or wire.
The sensor can either be an RTD, resistive thermal device or a thermocouple. In the case of RTD, the resistance of the device changes with the temperature. This resistive value is sent to a calibrated meter or gauge. A RTD device is far more accurate than a thermocouple. Plus or minus .1 of 1%. In the case of a thermocouple a small voltage is created by the device which varies with the temperature. This is sent to the reading device or gauge. Plus or minus 2 0r 3 degrees.
Yes, 8 gauge wire is thicker and stronger than 10 gauge wire. The lower the gauge number, the thicker the wire is. Therefore, 8 gauge weld wire fencing would be stronger and more durable than 10 gauge wire fencing.
No, 6 gauge steel is thicker than 10 gauge steel. The gauge number decreases as the thickness of the steel increases, so a lower gauge number indicates a thicker steel.
The upper quartile is the value such that a quarter of the data are greater than that value. Similarly, the lower quartile is the value such that a quarter of the data are lower than that value.
In gauge sizing, a lower number represents a larger diameter. Therefore, an 18 gauge nose ring has a larger diameter than a 19 gauge nose ring.
A little bit more than a 17 gauge but less than 19 guage.
The upper quartile of a set of data is a value such that a quarter of the observations are greater than that value. The lower quartile is similarly defined as the value such that a quarter of the observations are less than that value.
Less than $100.
Air and friction both being fluids, the resistive forces between them are more related to drag than friction.
The M37 was mge in 1949. Value depends on the condition and gauge, as a 20 would be worth more than a 12.
A lower acid value indicates lower levels of free fatty acids in a substance, which can result in better quality and stability. Higher acid values can lead to rancidity, off-flavors, and reduced shelf life in products like oils and fats.