Use a step down transformer 240 primary to 120 secondary. You must know what the connected load (amps) is so that you don't overload the transformer. Small Transformers are rated in VA.
Yes and you will have a spare terminal for future use
Because they are "in-phase". In order to get 240v, you need two 120v Alternating Current lines that are 180° out of phase, that is, opposite phases. Only when one line is +120v and the other -120v will you see 240v between the wires.
Off hand no but your explanations are not clear as to who is doing what to whom,,
120v and 240v
Actually, I have seen this in a respected electronics magazine (Elektor) quite some time ago: A diode (selected to be capable to handle the amps, the voltage and the heat from the bulb - if placed inside the lighting fixture) is used to "cut off" one half of the AC sine wave and thus sending pulses of 120V to an incandescent light bulb, simulating a simple dimming device. The proposal was meant to run 240V bulbs at 50% of their brightness but I am pretty certain this concept can be used to run 120V bulbs from 240V power. One other way of connecting 120V bulbs to 240V would be to connect two 120V bulbs OF THE SAME WATTAGE in SERIES, so the two bulbs form their own voltage divider. Not sure what happens if one bulb burns out - I would expect the other one to blow too, as a dying light bulb represents zero Ohms (plasma/arcing) for a few milliseconds before it goes dark forever.
In the US, both 120v and 240v will be needed for your home, as different appliances need different voltages. Your TV needs 120V, while your electric dryer and stove will need a 120V/240V supply. If you have an electric water heater, or central AC unit, they will need a 240V supply.
Yes and you will have a spare terminal for future use
T/F works without any change in frequency.... Er. K Godiyal. email: kuldeepgodiyal@gmail.com kuldeep.godiyal@medhaj.com
No.
It will work it you use 240 volt light bulbs.
You would need a step-up transformer or voltage converter to plug a device with a 240V AC plug into a 110V AC supply. Make sure the converter can handle the wattage of your device and has the correct plug type for your country.
Because they are "in-phase". In order to get 240v, you need two 120v Alternating Current lines that are 180° out of phase, that is, opposite phases. Only when one line is +120v and the other -120v will you see 240v between the wires.
You cannot safely plug a 2000 watt 240v appliance into a 120v 20 amp breaker without risking damage or fire hazard. To use the appliance, consider installing a step-up transformer to convert the voltage from 120v to 240v before plugging it in. This will ensure the appliance operates correctly without overloading the circuit.
Off hand no but your explanations are not clear as to who is doing what to whom,,
You can use 120v 10a 125w cable projectors 110-240v power in India.
Power adaptors are readily available that plug into Australia's 240v outlets, converting to 120v. Find them in travel, luggage and electronics stores.
No, you cannot convert a gas dryer hookup to an electric dryer hookup. Gas dryers require a 120V outlet for power, while electric dryers need a 240V outlet for power. You would need to install a new 240V outlet specifically for the electric dryer.