0
Add your answer:
Earn +20 pts
The electric bulb in your household circuits are connected in parallel what happens to the line current and line voltage as you turn on more light bulbs?
The line current increases when more bulbs are switched on in parallel, since more parallel current paths results in lower effective resistance. The line voltage should not change in response to any normal use of electric power in a single house.
An electric bulb reads 220V-100W if it is connected across a 200V line what will be the power consumed?
80
Why no electric shock from neutral line?
There is normally no voltage on the neutral line because the neutral line is grounded. However, and this is always important, do not assume that neutral is grounded, nor that there is not an elevated voltage on neutral or ground due to a possible ground fault.
How much current will an electric heater draw from a 110-volt line if the resistance of the heater when hot is 26.7 ohm?
4.12A. V=IR
Is three phase transmission line is example of bundle conductor?
'Bundled' conductors describe a line in which two or more conductors are supported from the same insulator chain. In the UK, 275-kV transmission lines typically use two conductors per line, and 400-kV transmission lines typically use four conductors per line. The purpose of bundling conductors is to spread the electric stress on the conductors (e.g. for four conductors, the same amount of electric flux will be 'shared' between the four conductors, rather than concentrated on the surface of one conductor).
Wire dangling from the electric line?
A wire dangling from an electric line is dangerous and should be reported to the local electric utility company immediately. Do not touch the wire or attempt to move it yourself to avoid any risk of electrocution. Keep a safe distance from the wire and warn others to do the same until it has been dealt with by professionals.
The bridegroom in lochinvar is what?
The bridge groom was a lord. You can get that from the line of "And the bridegroom stood dangling his bonnet and plume".
Why can't human beings sit safely on electric power lines?
Theoretically, human beings can sit safely on an individual overhead line conductor, providing no part of their body comes into contact with another conductor or the earth. In practise, of course, it's another story as it's highly improbable that anyone could approach a high-voltage line in the first place!
Why do you need to use a dry wooden pole to remove a person in electric shock from the electric line?
Using a dry wooden pole is important because wood is a poor conductor of electricity, which helps prevent the rescuer from getting shocked. The dry wooden pole serves as an insulator, allowing the rescuer to safely move the person away from the electric line without putting themselves at risk of electrical shock.
When was Chōshi Electric Railway Line created?
Chōshi Electric Railway Line was created in 1923.
When did Electric Short Line Railway end?
Electric Short Line Railway ended in 1956.
When was Electric Short Line Railway created?
Electric Short Line Railway was created in 1908.
What type of professional can convert an electric dryer hookup to a gas dryer hookup?
A licensed plumber or HVAC technician can convert an electric dryer hookup to a gas dryer hookup. It involves installing a gas line and ensuring the proper vents and connections are in place to safely operate the gas dryer. It's important to hire a professional to ensure the job is done correctly and safely.
When was Santa Monica Air Line - Pacific Electric - created?
Santa Monica Air Line - Pacific Electric - was created in 1875.
Why did your all wheel drive stop working on your aztek?
IT MAY HAVE TO DEAL WITH WHEEL HUB OR HUBS OUT OF LINE! OR GOING OUT . IT MAY HAVE TO DEAL WITH WHEEL HUB OR HUBS OUT OF LINE! OR GOING OUT . IT MAY HAVE TO DEAL WITH WHEEL HUB OR HUBS OUT OF LINE! OR GOING OUT .
What is the deal with the 360-30 line?
390
What is the angle between the electric dipole moment and the electric field strength due to it on axial line?
The angle between the electric dipole moment and the electric field strength on the axial line is 0 degrees (or parallel). This is because on the axial line, the electric field points in the same direction as the electric dipole moment, resulting in the minimum potential energy configuration for the dipole.
