0
Still curious? Ask our experts.
Chat with our AI personalities
BeauYou're doing better than you think!
Chat with Beau
ViviYour ride-or-die bestie who's seen you through every high and low.
Chat with Vivi
BlakeAs your older brother, I've been where you are—maybe not exactly, but close enough.
Chat with BlakeAdd your answer:
Earn +20 ptsQ: How do you eliminate excessive moisture from the home?
Write your answer...
Submit
Still have questions?
Continue Learning about Electrical Engineering
If electrode use in welding has moisture what effect will it have on the weld?
Electrodes with too much moisture may lead to cracking or porosity.
What is the Radar used to eliminate clutter in navigational application?
tracking radar
Why gate is closer to cathode in scr?
A: To partially eliminate the problems with cathode current hugging
What is the purpose of breather in transformer?
To allow the transformer to "free breathe" and yet prevent any moisture from entering. The desiccant in the breather removes any moisture in the air before it enters the tank or conservator.
Why do you need heaters in electrical motors?
To prevent the short circuit current causing the moisture at the motor winding. So, we need the heaters in the electrical motors which is used at the humidity environment to take off the moisture by using heating effect.
Trending Questions
I have a 5000 watt Honda generator. How much of a voltage drop will a 25 foot portable generator cord cause?
What is mean BFW11?
Can you use two 110V on generator to make 240V?
Crawling in induction motor is caused by?
Who is the canadian who invented the light bulb?
Do you need a licenced electrician to hang conduit for low voltage cable?
Where do you place the copper ground when no green wire is available?
Can you add a second light off an existing switch?
What are digital instruments?
Where can I get a wiring diagram for a pump relay switch made by Hunter Irrigation Company?
What is a two way lever switch?
Who created the light bulb first Thomas Edison or Joseph Swan?
Can you install a main breaker box between studs on a outside wall?
What is Arc Energy in Welding?
How much watts for 2 ton AC?
Why should core saturation of a conventional impedance matching transformer be avoided?
What is the meaning of no load and full load on a power supply?
Transformer Output power less than input power?
Magnetic flux density can be measured by using?
Why are voltages for registering a bit of 1 on Ethernet so low when transmitting electricity on copper wire is high?
Copyright ©2025 Infospace Holdings LLC, A System1 Company. All Rights Reserved. The material on this site can not be reproduced, distributed, transmitted, cached or otherwise used, except with prior written permission of Answers.