Tags New Electrical Work

Animals & Plants Arts & Entertainment Auto Beauty & Health Books and Literature Business Electronics Engineering & Technology Food & Drink History Hobbies Jobs & Education Law & Government Math People & Society Science Social Studies Sports Travel & Places

0

Subjects>Engineering & Technology>Electrical Engineering

How many amps does a 0.05 transformer provide?

Gjjsrj ∙

Lvl 1

∙ 14y ago

Updated: 9/19/2023

You have not provide enough information. You don't explain what 0.05 references. You need to know the secondary voltage and resistance to calculate current.

Wiki User

∙ 14y ago

Still curious? Ask our experts.

Chat with our AI personalities

Lao

The path is yours to walk; I am only here to hold up a mirror.

Chat with Lao

Vivi

Your ride-or-die bestie who's seen you through every high and low.

Chat with Vivi

Fran

I've made my fair share of mistakes, and if I can help you avoid a few, I'd sure like to try.

Chat with Fran

Add your answer:

Earn +20 pts

Q: How many amps does a 0.05 transformer provide?

Write your answer...

Submit

Still have questions?

imp

Continue Learning about Electrical Engineering

What is the Printed circuit board annular ring spec?

According to the following website:http://www.interfacebus.com/glossary-of-terms-minimum-annular-ring.htmlMinimum Annular RingThe minimum annular ring on a plated thur-hole is the minimum amount of copper (at the narrowest point) between the hole and the edge of the pad after plating of the finished hole. MIL-STD-275E and IPC class 3 calls for a minimum annular ring of 0.05mm (0.002") edge of hole to edge of pad. MIL-STD-275E also calls out .005 inches for via to trace distance. Minimum Annular Ring; PWB Internal ViaBoth diagrams indicate minimum annular ring measured from the outside ring of the pad and to the inside diameter of the plated thru-hole for an external pad [below], or to the center of the plated via for an internal pad [above].Minimum Annular Ring; PWB External PadMinimum Annular Ring applies regardless of the shape of the PCB pad. The next page shows two examples of different pad shapes.More Printed Wiring Board Terms

Trending Questions

How many flip-flops are required for mod 3 counter? How do you convert 230v to 208 volts single phase? How do you use scr as a diode? What is Direct online Starter and its disadvantage? What is the thyristor firing circuit? Why voltage divider bias is called self bias? How many rupees is electricity per unit? Where do usually series circuit used? What is a panel puller used for? Is ground wire important? What is mega watt? What does load cell used? Why havent i got heat coming from my electric fire its just blowing cold air? What resistance value is add to convert a galvanometer into a voltmeter? What is the difference between a Y - delta starter and a star - delta starter? What does ohm means? Can you legally splice 250 mcm and what would you use? What device will allow ac current to flow one way and not the other? What is the pin configuration of 4-pin stepper motor? What are the uses for electrical energy?

Resources

Top Categories

Product

Company

Copyright ©2025 Infospace Holdings LLC, A System1 Company. All Rights Reserved. The material on this site can not be reproduced, distributed, transmitted, cached or otherwise used, except with prior written permission of Answers.